GASKET 4D6336 - Caterpillar

There may be several specific safety messages on your engine. The exact location and a description of the messages are reviewed in this section. Please become familiar with all of the messages.Ensure that all of the messages are legible. Clean the messages or replace the messages if the words cannot be read or if the illustrations are not visible. Use a cloth, water, and soap for cleaning the messages. Do not use solvents, gasoline, or other harsh chemicals. Solvents, gasoline, or harsh chemicals could loosen the adhesive that secures the messages. The messages that are loosened could drop off the engine.Replace any message that is damaged or missing. If a message is attached to a part of the engine that is replaced, install a new message on the replacement part. Your Caterpillar dealer can provide new messages.The safety messages that may be attached on the engine are illustrated and described below.Crankcase Covers
Illustration 1 g00386802
Location of the safety message for the crankcase coversThe safety messages for the crankcase covers are located on the crankcase covers.
g00123185
Flash fire may result in personal injury, if crankcase covers are removed within fifteen minutes after emergency shut down. Do not restart engine until cause for shutdown has been corrected.
Engine Lifting
Illustration 2 g00580494
Location of the safety message for lifting the engineThe safety message for lifting the engine is located on the valve covers.
g00306083
Improper lift rigging can allow unit to tumble causing injury and damage.
Before lifting the engine, read this Operation and Maintenance Manual, "Engine Lifting" topic (Operation Section).If improper equipment is used to lift the engine, injury and damage can occur. Use cables that are properly rated for the weight. Use a spreader bar and attach the cables according to the information on the warning label.Fuel Injectors
Illustration 3 g00749734
Locations of the safety message for the fuel injectorsThe safety message for the fuel injectors is located on the electronic control module (ECM) (1) and the valve covers (2) .
g00103125
Electrical shock hazard. The electronic unit injector system uses 90-120 volts.
The ECM sends a high voltage signal to the fuel injectors. To help prevent personal injury, disconnect the fuel injector connector. Do not come in contact with the harness connector for the fuel injector while the engine is operating.