GASKET 4L6706 - Caterpillar

Generator Control Screen
The "Generator control screen" is used to adjust the generator voltage and frequency during generator setup. The screen is also used to monitor generator paralleling and to monitor all relative system voltages and currents.Basic operations on the "Generator Control Screen":
Generator and bus voltage, frequency, and power factor.
Synchronization scope shows the phase relationship between the bus and the generator
Generator breaker amperage and power status
Touch and move slider to adjust generator voltage and frequency when generator is running and breaker is open
Touch manual to enable manual generator operation, the push button closes the breaker when generators are in manual mode
Illustration 1 g02523176
Generator control screen (1) Generator voltage vs. bus voltage (2) Generator frequency vs. bus frequency (3) Generator amps vs. bus amps (4) Relative generator frequency (5) Generator circuit breaker status display (6) Synch meter (7) Engine control switch (8) Voltage and freq adjust controls (9) Manual circuit breaker close button (10) Sync mode control switch
Generator voltage vs. bus voltage (1)
frequency vs. bus frequency (2)
Generator amps vs. bus amps (3)
Relative generator frequency (4) Generator Circuit Breaker status display (5) - Displays status of the circuit breakers.Synch Meter (6) - Displays the synchronization of the generator to the load.Engine Control Switch (7) - The switch can be placed in the positions of: Off, Auto, Manual and CooldownSync Mode Control Switch (10) - The switch can be placed in the positions of: Off, Auto, Manual and CheckVoltage and Freq adjust controls (8) - These sliders are only operational when the circuit breaker is open and the generator is not on the bus.Manual Circuit Breaker Close Button (9) - Closes the circuit breaker.Switches/Buttons
Touching the "Hot Area" which you want the switch to be positioned operates the following switches and buttons.
Engine Control Switch
Sync Mode Switch
Breaker Close Button
Voltage / Frequency sliderEngine Control Switch
Switch Operations
Basic operations on the "Engine Control Switch", To control the mode in which the generator operates :
Illustration 2 g02522816
Engine control switch
Auto : Allows for all automatic functions to occur.
Manual : Starts the generator.
Cool Down Stop : Unloads generator, opens breaker, then performs Cooldown, generator is unavailable.
Off/Reset : Turns off generator, immediately opens the breaker. Note: The presence of a shutdown alarm on a generator will lock the ECS switch on the Off/Reset position.
If system enters "Emergency Mode" and the ECS is in Manual with the "Sync Mode" switch in Auto, the breaker will close automatically.
Sync Mode
Switch Operations
To control the mode, in which you want the generator to sync.
Illustration 3 g02522817
Sync mode switchBasic operations on the "Sync Mode Switch":
Auto : Allows for all automatic synchronization functions.
Manual : Allows for manually closing the generator breaker from control screen push button.
Check : Holds the generator in sync with the bus without allowing closing of the breaker.
Off : Will not attempt to synchronize generators to a hot bus. Does not allow the generator breaker to close.Manual Close Parallel Button
Allows operator to close the generator button in sync manually.
Single "Hot Area" is touched to send signal to the controller to close the generator breaker.Note: Typically the sync