GASKET 4L9760 - Caterpillar

This Special Instruction provides the procedure for installing anchorage points on certain 994F and 994H Large Wheel Loaders.The installation of anchorage points will be for the following:
Front of FOPS canopy (two points).
Rear of FOPS canopy (two points).Do not perform any procedure that is outlined in this publication until you understand the information that is contained in this document. Do not order any parts until you understand the information that is contained in this document.Safety
Personal injury can result from flame cutting or welding on painted areas.The effect of gasses from burned paint is a hazard to the person doing the cutting or welding.Do not flame cut or weld on painted areas.
Personal injury or death can result from fumes, gases and ultraviolet rays from the weld arc.Welding can cause fumes, burn skin and produce ultraviolet rays.Keep your head out of the fumes. Use ventilation, exhaust at the arc, or both, to keep fumes and gases from your breathing area. Wear eye, ear and body protection before working.Protect yourself and others; read and understand this warning. Fumes and gases can be dangerous to your health. Ultraviolet rays from the weld arc can injure eyes and burn skin. Electric shock can cause death.Read and understand the manufacturer's instructions and your employer's safety practices. Do not touch live electrical parts.See "American National Standard Z49.1, Safety in Welding and Cutting" published by the American Welding Society.American Welding Society
2501 N.W. 7th Street
Miami, Florida 33125
See "OSHA Safety and Health Standards, 29 CFR 1910", available from U.S. Department of Labor.U.S. Department of Labor
Washington, D.C. 20210
Required Parts
Table 1
Required Parts    
Item    Qty    Part Number    Description    
1     4     293-4578     Bracket Assembly    
2     4     8T-7038     Film    
3     3a     4     299-5776     Film (1)    
3b 4     299-5775     Film (2)    
( 1 ) For all USA machines.
( 2 ) For all machines outside the USA.Installation Procedure
Illustration 2 g03812998
Front view of cab (1) 293-4578 Bracket Assembly
Illustration 3 g03813018
Inside view of right side FOPS (A) 15 mm (0.6 inch) from bottom edge (B) 30 mm (1.2 inch) from front edge (W1) 6 mm (0.24 inch) fillet weld (1) 293-4578 Bracket Assembly
Install right and left front bracket assembly (1) on the inside of the FOPS canopy. Refer to Illustration 3 for placement and welding instructions.
Install film (2) and film (3) above bracket assembly (1) on both sides of front FOPS.
Illustration 4 g03814005
Rear view of cab (1) 293-4578 Bracket Assembly
Illustration 5 g03813020
Right side view of FOPS (B) 30 mm (1.2 inch) from bottom edge (C) 12.7 mm (0.5inch) from rear edge (W1) 6 mm (0.24 inch) fillet weld (1) 293-4578 Bracket Assembly
Install bracket assembly (1) to the right and left rear on the outside of the FOPS canopy. Refer to Illustration 5 for placement and welding instructions.
Illustration 6 g03813022
Right rear side view of FOPS (1) 293-4578 Bracket Assembly (2) 8T-7038 Film (3) 299-5776 Film
Install film (2) and film (3)