GASKET-GEAR CASE 4N4384 - Caterpillar

Marine Engine:
C15 MARINE (S/N: RLA1-UP)
C18 MARINE (S/N: CKH1-UP; C1J1-UP)
C32 MARINE (S/N: RNC1-UP)
Engine News SEBD9541, 19 May 2008, "Procedure to Repair a Service Meter that Runs Constantly". Disregard the previous article, and refer to the following article.The 197-8832 Service Meter Gp runs constantly when power is applied to the ECM.The 300-5538 Wire contains a 1 kOhm, 2 Watt resistor. This wire can be installed in the Start/Stop control group if the engine is equipped with a 203-4624 Auto Start/Stop Control. The 300-5538 Wire and the connections for the Start/Stop control harness need to be sealed with heat shrink tubing. The 114-2505 Film can be applied to the service meter in order to provide the correction factor for the correct number of engine hours.
Illustration 1 g01405231
Wiring schematic
Illustration 2 g01391062
Wiring schematic (1) Apply heat shrink tubing to the connections of the Start/Stop control harness.The new components are installed at the factory on the serial numbers that are listed in Table 1.
Table 1
Effective serial numbers    
S/N:C1J1088-UP    
S/N:CKH3071-UP    
S/N:RLA910-UP    
S/N:RNC3073-UP