GASKET 4W7333 - Caterpillar

Fuel leaked or spilled onto hot surfaces or electrical components can cause a fire. Clean up fuel spills immediately.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products.Dispose of all fluids according to local regulations and mandates.
Prime the fuel system in order to fill the fuel filter with fuel. Prime the fuel system after the fuel filters have been changed.
Park the machine on a level surface. Engage the parking brake and stop the engine.
Raise the hood. Refer to Operation and Maintenance Manual, "Hood Control".
Illustration 1 g03487337
Hold switch (1) upward in order to operate the electric fuel priming pump. The electric fuel priming pump will fill the engine fuel lines and the fuel filters with fuel. Note: The engine start switch must be in the ON position in order to prime the fuel system.
Lower the hood.
Operate the priming pump in order to build fuel pressure. As the fuel pressure increases, the priming pump will come under load. Listen for the priming pump to come under load. Do not continue priming the fuel system after the priming pump is under load. Do not operate the pump for more than two minutes.
Start the engine. If the engine starts but the engine runs rough, continue to run the engine at low idle until the engine runs smoothly. If the engine will not start after several attempts, consult your Caterpillar dealer.