GASKET 5352258 - Caterpillar

Start By:a. remove camshaftb. remove flywheel housingc. remove pistons and connecting rods 1. Remove the rear camshaft bearing with Tooling (A).2. Remove the remainder of the camshaft bearings with Tooling (A). Start at the rear of the engine block, and move toward the front.Install Camshaft Bearings
1. Use Tooling (A) to install the camshaft bearings in the cylinder block starting with the rear bearings (see the illustrations for the correct dimensions).2. All camshaft bearings must be installed with the oil holes in the bearings 90 15 degrees from the oil holes in the cylinder block. See the Specifications Manual for more information on the cylinder block.3. After assembly the inside diameter of bearings (1) must be 69.969 0.048 mm (2.7547 .0019 in). The remainder of the bearings must have an inside diameter of 69.982 0.061 mm (2.7552 .0024 in).End By:a. install camshaftb. install pistons and connecting rodsc. install flywheel housing