GASKET 5B5689 - Caterpillar

Do not operate or work on this machine unless you have read and understand the instructions and warnings in the Operation and Maintenance Manual. Failure to follow the instructions or heed the warnings could result in injury or death. Contact any Caterpillar dealer for replacement manuals. Proper care is your responsibility.
Working with electrical circuits is hazardous and exposes personnel to electrical potential. To ensure safe operation, personnel must be trained in proper operating procedures. Bodily contact with electrical potential will cause serious personal injury or death.
System Setup Screen
Select each touch area and enter the correct value.
Illustration 1 g02507316
System initial setup screen (1) System voltage (2) System frequency (3) Number of generators (4) System type (5) DTI available (6) System kW/kVAR scale max (7) System voltage scale max (8) System current scale max
Enter the "System Voltage" (1) .
Enter the "System Frequency" (2) .
Enter the "Number of Generators" (3) .
Select the "System Type" (4) .
Select the "Data Table Interface" (DTI) Available (5) if there is one on the system.
Set the metering scaling for kW/kVAR, system voltage, and system current by performing steps 5 thru 9.
Touch the "System kW/kVAR Scale Max" display (6) and enter a maximum meter scale. The meter scale will change to indicate the selected scaling. Typically the max scale should be the combined rated kW of all generators. When the scale is correct precede to the set the "System Voltage Scale Max".
Touch the "System Voltage Scale Max" display (7) and enter a maximum meter scale. The meter scale will change to indicate the selected scaling. Typically the max scale should be the rated voltage of all generators.
Touch the "System Current Scale Max" display (8) and enter a maximum meter scale. The meter scale will change to indicate the selected scaling. Typically the max scale should be the combined maximum rated current of all generators.When the system current scale is correct then continue to "Generator Setup Screens".Touch the Continue button located at lower left-hand corner of the screen to continue.Generator Setup Screens
Select each touch area and enter the correct value.
Illustration 2 g02507680
Generator initial setup screen (9) Rated voltage (10) Rated frequency (11) Rated kW (12) Rated current (13) Rated kVAR (14) CT primary size (15) kW/kVAR scale max (16) Voltage scale max (17) Current scale max (18) Voltage control (19) Speed controlSet up each generator as follows:
Enter "Rated Voltage" (9). Use the "Rated Voltage" as found on the CAT engine /generator rating plate mounted on the engine/generator.
Enter "Rated Frequency" (10). Use the "Rated Frequency" as found on the CAT engine/generator rating plate mounted on the engine/generator.
Enter "Rated kW" (11). Use the "Rated kW" as found on the CAT engine/generator rating plate mounted on the engine/generator.
Enter "Rated Current" (12). Use the "Rated Current" as found on the CAT engine/generator rating plate mounted on the engine/generator.
Enter "Rated kVAR" (13). Use the "Rated kVAR" as found on the CAT engine/generator rating plate mounted on the engine/generator.
Enter the "Current Transformer (CT) Primary" size (14) .Entry must match the current transformer ratio. For example a