GASKET 5H4499 - Caterpillar

Removal Procedure
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Personal injury can result from hydraulic oil pressure and hot oil.Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system.Make sure all of the attachments have been lowered, oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand.
Note: Put identification marks on all lines, on all hoses, on all wires, and on all tubes for installation purposes. Plug all lines, hoses, and tubes. This helps to prevent fluid loss and this helps to keep contaminants from entering the system.
Illustration 1 g00878800
Loosen clamps (1). Remove hose (2) .
Remove tubes (3) and (4) .
Illustration 2 g00878875
Remove clamps (5) and (7) .
Move hose (6) away from the access cover.
Illustration 3 g00878879
Remove clamp (8). Move harness (11) away from the access cover.
Remove bolts (9). Remove access cover (10) .
Illustration 4 g00878883
Disconnect electrical connector (12) .
Remove two bolts (13) and modulating solenoid valve (14) .