GASKET 6E2802 - Caterpillar

Removal Procedure
Drain the coolant from the cooling system into a suitable container for storage or disposal. Refer to Operation and Maintenance Manual, "Cooling System Coolant - Change".
Illustration 1 g02342842
Disconnect tube assembly (4).
Remove clamp assembly (1). Note: Clamp assembly (3) is a one time use part. Discard the clamp assembly if the clamp is loosened.
Remove clamp assembly (3) and position the tube assembly out of the way. Discard clamp assembly (3).
Remove bolts (2) and remove the tube assembly.
Illustration 2 g02342843Note: Clamp assembly (5) is a one time use part. Discard the clamp assembly if the clamp is loosened.
Remove clamp assembly (5) and discard the clamp assembly.
Remove clamp assembly (6).
Remove bolts (8) and remove tube assembly (7).
Illustration 3 g02342844
Remove bolts (10) and remove exhaust cooler (9). The weight of exhaust cooler (9) is approximately 16 kg (35 lb).
Repeat 1 through 9 for the opposite side. Installation Procedure
Note: Check the O-ring seals, the gaskets, and the seals for wear or for damage. Replace the components, if necessary
Install exhaust cooler (9) in the reverse order.
Tighten clamp assemblies (5) and (3) to a torque of 7.5 1 N m (66 9 lb in).
Lubricate the O-ring seals that are found on tube assemblies (7) and (2) with the lubricant that is being sealed.