GASKET 6F7557 - Caterpillar

Ensure that all safety information, warnings, and instructions are read and understood before any operation or any maintenance procedures are performed.The user is responsible for the performance of maintenance, including all adjustments, the use of proper lubricants, fluids, filters, and the replacement of components due to normal wear and aging. Failure to adhere to proper maintenance intervals and procedures may result in diminished performance of the product and/or accelerated wear of components.Use mileage, fuel consumption, service hours, or calendar time, WHICH EVER OCCURS FIRST, to determine the maintenance intervals. Products that operate in severe operating conditions may require more frequent maintenance.Note: Before each consecutive interval is performed, all maintenance from the previous interval must be performed.All the following will affect the oil change interval: operating conditions , fuel type , oil type, and size of the oil sump . Scheduled oil sampling analyzes used oil to determine if the oil change interval is suitable for your specific engine.Refer to this Operation and Maintenance Manual , "Engine Oil and Filter - Change" to determine the oil change interval that is suitable for your specific engine.To determine the maintenance intervals for the overhauls, refer to this Operation and Maintenance Manual , "Maintenance Recommendations" .Unless other instructions are provided, perform maintenance and perform repairs under the following conditions:The starting system is disabled.The engine is stopped.The generator does not pose an electrical shock hazard.The generator is disconnected from the load.When Required
Battery - Recycle
Battery - Replace
Battery or Battery Cable - Disconnect
Circuit Breakers - Reset
Engine Air Cleaner Element (Dual Element) - Inspect/Clean/Replace
Engine Air Cleaner Element (Single Element) - Inspect/Clean/Replace
Fuel System - Prime
Fuel System Primary Filter/Water Separator - Drain
Generator - Dry
Generator Bearing - Lubricate
Generator Set - Test
Generator Set Alignment - Check
Generator Winding - Test
Maintenance Recommendations
Daily
Air Starting Motor Lubricator Oil Level - Check
Air Tank Moisture and Sediment - Drain
Control Panel - Inspect/Test
Coolant Level - Check
Engine Air Cleaner Service Indicator - Inspect
Engine Air Precleaner - Check/Clean
Engine Oil Level - Check
Fuel Tank Water and Sediment - Drain
Generator Bearing Temperature - Test/Record
Generator Load - Check
Jacket Water Heater - Check
Power Factor - Check
Voltage and Frequency - Check
Walk-Around Inspection
Every Week
Air Inlet Filter - Inspect/Clean/Test
Battery Charger - Check
Electrical Connections - Check
Generator - Inspect
Generator Lead - Check
Space Heater - Test
Stator Winding Temperature - Test
Initial 250 Service Hours
Engine Valve Lash - Check
Fuel Injector - Inspect/Adjust
Every 250 Service Hours
Battery Electrolyte Level - Check
Belts - Inspect/Adjust/Replace
Coolant Sample (Level 1) - Obtain
Cooling System Supplemental Coolant Additive (SCA) - Test/Add
Engine Oil Sample - Obtain
Fan Drive Bearing - Lubricate
Hoses and Clamps - Inspect/Replace
Radiator - Clean
Every 500 Service Hours
Air Shutoff - Test
Engine Oil and Filter - Change
Every 1000 Service Hours
Coolant Sample (Level 2) - Obtain
Engine - Clean
Engine Crankcase Breather - Clean/Replace
Engine Protective Devices - Check
Fuel System Primary Filter (Water Separator) Element - Replace
Fuel System Secondary Filter - Replace
Generator Winding Insulation - Test
Rotating Rectifier - Inspect/Test
Every 2000 Service Hours
Air Starting Motor Lubricator Bowl - Clean
Crankshaft Vibration Damper - Inspect
Engine Mounts - Inspect
Generator Set Vibration - Test/Record
Stator Lead - Check
Turbocharger - Inspect
Every Year
Generator Bearing - Inspect
Varistor - Check
Varistor - Inspect
Every 3000 Service