GASKET KIT 6V1341 - Caterpillar

Illustration 1 g00649772
(1) Bolts
(2) Plate
(3) Cap
(4) Bolts
Illustration 2 g00649773
Section A-A
(5) Pin As
(6) Thrust washer
(7) Bearing
(8) Bolts
(9) ShimsAdjustment Procedure For The End Play
Use three bolts (1) that are spaced 120° from each other to assemble retainer plate (2) to pin (5). Do not use shims (3) now.
Evenly, tighten bolts (1) to 200 25 N m (148 18 lb ft). Install bolts (4) and washers, but do not tighten bolts (4) now.Note: The chamfer on the inside thrust washer (6) must face away from bearing (7). The chamfer provides clearance for the radius on the thrust face of pin (5).
Use a depth micrometer to measure the distance from the top of retainer plate (2) to the end of pin (5). Measure this distance through the hole in retainer plate (2).
Remove bolts (1) and retainer plate (2). Use an outside micrometer to measure the thickness of retainer plate (2).
Subtract the thickness of retainer plate (2) from the distance that was found in Step 3. This is the gap between pin (7) and retainer plate (2).
Add 0.25 mm (0.010 inch) to the distance that was found in Step 5. This is the shim pack thickness. Install the correct number of shims from shim pack (9).
Use six bolts (1) and washers to install retainer plate (2) and shims (9). Torque bolts (1) to 620 80 N m (457 59 lb ft).
Tighten bolts (4) with washers to 1125 100 N m (830 75 lb ft).Note: Apply 4C-5593 Anti-Seize Lubricant to the bore of the cap prior to assembly.