GASKET KT-V G 6V2576 - Caterpillar

Which Generate This Code:The Electronic Control Module (ECM) detects all of the following conditions:
Hydraulic oil temperature is greater than 90 °C (194 °F) for more than four seconds.
600-03 Hydraulic Temperature Sensor open/short to +batt (Machine ECM) is not active.
600-04 Hydraulic Temperature Sensor short to ground (Machine ECM) is not active.System Response:The ECM will log the derate event. The maximum derate is 15 percent of the full power. The ECM will restore full power after the hydraulic oil temperature returns below 87 °C (188 °F) for at least one second.
Low power
There may be a problem with the hydraulic system.Test Step 1. Check for Diagnostic Codes
Connect the Caterpillar Electronic technician Cat ET to the service tool connector.
Turn the keyswitch to the ON position.
Check for any active diagnostic codes and/or logged diagnostic codes.Expected Result:No diagnostic codes are present.Results:
OK - Proceed to Test Step 2.
Not OK - Repair: Repair the diagnostic codes that are present. Refer to the appropriate topic in the "Troubleshooting With a Diagnostic Code" section of this manual.Ensure that the repair eliminates the problem. Stop.Test Step 2. Perform a Check of the Hydraulic System
Perform a check of the hydraulic system.Expected Result:There are no problems with the hydraulic system.Results:
OK - There may be an intermittent problem.Repair: Monitor the operation of the machine.Repair the problem.Ensure that the repair eliminates the problem. Stop.
Not OK - Repair: Repair the problem.Ensure that the repair eliminates the problem. Stop.