GASKET KIT- 6V5497 - Caterpillar

Which Generate This Code:The Electronic Control Module (ECM) detects all of the following conditions:
The engine has been running for at least three seconds after engine speed is within 50 rpm of low idle.
Coolant flow is lost for ten seconds.System Response:The ECM will log the event.
None
There may be a problem with the cooling system.
There may be a problem with the coolant flow switch.Test Step 1. Check for Diagnostic Codes.
Connect Caterpillar Electronic Technician (ET) to the service tool connector.
Turn the keyswitch to the ON position.
Check for any active diagnostic codes or logged diagnostic codes.Expected Result:No diagnostic codes are present.Results:
OK - No diagnostic codes are present. Proceed to Test Step 2.
Not OK - Diagnostic codes are present.Repair: Repair the diagnostic codes that are present. Refer to the appropriate topic in the "Troubleshooting With a Diagnostic Code" section of this manual. Ensure that the repair eliminates the problem.STOPTest Step 2. Perform a Check of the Cooling System.
Verify that the coolant is filled to the proper level.
Perform a check of the cooling system. Refer to Troubleshooting, "Coolant Temperature is Too High" for possible causes.Expected Result:There are no problems with the cooling system.Results:
OK - There may be an intermittent problem.Repair: Monitor the operation of the engine. Repair the problem. Ensure that the repair eliminates the problem.STOP
Not OK - There are problems with the cooling system.Repair: Repair the problem. Ensure that the repair eliminates the problem.STOP