GASKET KIT- 6V5963 - Caterpillar

Install two seals (17) in rod assembly (7). Apply 4C-4032 Bearing Mount Compound to both seals before installing in rod assembly (7).
Illustration 22 g00830019
Illustration 23 g00830022
Section B-B
Illustration 24 g00831349
Install seal (15) and backup ring (16) on head assembly (5). Refer to Illustration 24 for the correct installation of backup ring (16).Note: Before you assemble head assembly (5) to cylinder assembly (8), lubricate the sealing lip of seal (15) with the lubricant that is being sealed.
Illustration 25 g00830019
Illustration 26 g00830020
Section B-B
Install seal (12), backup ring (13), and seal (14) onto head assembly (5). Apply 4C-4032 Bearing Mount Compound to seal (14) before installing in head assembly (5).Note: Before you assemble head assembly (5) onto rod assembly (7), lubricate the sealing lip of seal (12) and seal (14) with the lubricant that is being sealed.
Illustration 27 g00830018
Use Tooling (B) and a suitable lifting device to install head assembly (5) onto rod assembly (7). Head assembly (5) weighs approximately 61 kg (134 lb).Note: Before installing head assembly (5), align the bolt pattern of head assembly (5) with the bolt pattern of cylinder assembly (8).
Use a plastic hammer to carefully position head assembly (5) onto rod assembly (7).
Illustration 28 g00829683
Install ball (11), plate (10) and wear ring (9) onto rod assembly (7).
Illustration 29 g00832481
Use a suitable lifting device to assemble rod assembly (7) and head assembly (5) to cylinder assembly (8). The combined weight of rod assembly (7) and head assembly (5) is approximately 490 kg (1080 lb). Cylinder assembly (8) weighs approximately 390 kg (860 lb).Note: Before you install bolts (6), align the bolt pattern in cylinder assembly (8) with the bolt pattern in head assembly (5).
Illustration 30 g00829680
View A-A
Attach rod assembly (7) and head assembly (5) to cylinder assembly (8) by using 16 bolts (6) and 16 washers. Use Tooling (C) and Tooling (D) to tighten bolts (6).
Illustration 31 g00829676
View A-A
Illustration 32 g00829679
Section B-B
Install the following items:
two O-ring seals (4)
two covers (3)
four bolts (2) and the washersUse Tooling (C) and Tooling (D) to tighten bolts (2).
Illustration 33 g00829674
Illustration 34 g00829678
View A-A
Remove four plastic plugs and install four grease fittings (1).End By:
Install the rear suspension cylinder. Refer to Disassembly and Assembly, "Rear Suspension (Cylinder) - Install" for the correct procedure.
Install the pressure sensor of VIMS for the suspension cylinder.