GASKET KT- 6V9702 - Caterpillar

Removal Procedure
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products.Dispose of all fluids according to local regulations and mandates.
Note: Cleanliness is an important factor. Before the removal procedure, the exterior of the component should be thoroughly cleaned. This will help to prevent dirt from entering the internal mechanism.
Personal injury or death can occur if personnel are trapped between the wheel and the frame.The steering system is hydraulically controlled and wheels can crush personnel during movement.Use caution when working between the wheels and the frame. If the wheels must be turned, ensure that all personnel are clear of the machine before any movement.
Personal injury or death can occur if personnel are trapped between the wheel and the frame.The steering system is hydraulically controlled and wheels can crush personnel during movement.Use caution when working between the wheels and the frame. If the wheels must be turned, ensure that all personnel are clear of the machine before any movement.
Personal injury can result from being struck by parts propelled by a released spring force.Make sure to wear all necessary protective equipment.Follow the recommended procedure and use all recommended tooling to release the spring force.
Park the machine on level ground and engage the parking brake. Use the engine start switch in order to stop the engine. Wait for the accumulators to discharge completely. If you suspect that the accumulators did not discharge properly, report the condition. See Operation and Maintenance Manual, "Steering Accumulator Pressure - Release" for further information.
Illustration 1 g00948071
Remove outer filter (1) from filter base assembly (2).
Illustration 2 g00948082
Remove bypass valve (3) from filter base assembly (2).
Illustration 3 g00949115
Remove plunger (5) and spring (4) from plug (3). Installation Procedure
Illustration 4 g00949115
Install spring (4) and plunger (5) on plug (3).
Illustration 5 g00948082
Install bypass valve (3) in filter base assembly (2).
Illustration 6 g00948071Note: If necessary, install new filter elements.
Install outer filter (1) on filter base assembly (2).
Check filter base assembly (2) for leaks.