GASKET 7C1151 - Caterpillar

Table 1
Configuration Parameter Default Value in ET Options
ECM Identification Parameters
Equipment ID Not programmed Test
Engine serial number Not programmed Engine serial number
ECM serial number (read only) Hardware dependent N/A
Software group part number (read only) File dependent N/A
Software group release date (read only) File dependent N/A
Software group description (read only) File dependent N/A
Selected Engine Rating
Rating number File dependent Rating number file dependent (1 or 2 or 3 or 4)
Rating information
Rating number (File dependent)
Rated power (File dependent)
Rated peak torque (File dependent test)
Spec (File dependent)
Engine rating interlock (File dependent)
Rated power File dependent File dependent
Rated peak torque File dependent File dependent
Top engine speed range File dependent File dependent
Test spec File dependent File dependent
Rated engine speed File dependent File dependent
Engine/Gear Parameters
Engine location Port Port, center, starboard, engine #1 - engine #5
Number of synchronized engine configuration 1 1 - 5
Low idle speed 600 550 rpm - 700 rpm
High idle speed Rating dependent File dependent (Rating dependent)
Maximum trolling engine speed 900 rpm 751 rpm - 1200 rpm
Secondary throttle enable status Enabled Disabled
Tachometer frequency configuration 113 12 - 500
System operating voltage configuration Unavailable parameter Unavailable
Cold cylinder cutout Enabled Enabled
Disabled
Torque limit enable status Disabled Enabled
Disabled
Maximum engine torque limit File rating dependent File rating dependent
Minimum engine torque limit File rating dependent File rating dependent
Secondary engine ECM installation status Not installed Installed
Not installed
Cooldown speed 600 rpm 300 rpm - 1600 rpm
Cooldown duration 0 0 - 30
Engine pre-lube duration 0 0 - 223
Crank duration 30 0 - 60
Maximum number of crank cycles 1 1 - 10
Crank terminate RPM 400 100 - 500
Tertiary desired speed input configuration Not installed Installed
Not installed
Bollard test time remaining 60 minutes 0 - 60 minutes
Optional Sensor Parameters
Transmission oil temperature sensor Not installed Installed
Not installed
Transmission oil pressure sensor Not installed Installed
Not installed
Coolant level sensor Installed Installed
Not installed
Fuel level sensor installation status Not installed Installed
Not installed
Engine oil temperature installation status Installed Installed
Not installed
Aftercooler coolant level sensor status Not installed Installed
Not installed
Unfiltered engine oil pressure sensor installation Not installed Installed
Not installed
Unfiltered fuel pressure sensor installation status Not installed Installed
Not installed
Engine coolant pressure sensor installation status Not installed Installed
Not installed
Maintenance Parameters
Engine oil capacity 80.5 L (85 qt) 18 L (19 qt) to 100 L (106 qt)
Maintenance indicator mode Off Auto-fuel, auto-hour, manual-fuel, manual l-hour
Fuel correction factor 0% -64% to 63%
PM1 interval 0 L 0 L
System Settings
FLS Not programmed -128 to 127
FTS Not programmed -128 to 127
Parameters
Customer password # 1 Not programmed 8 character string
Customer password # 1 Not programmed 8 character string
Security Access Parameters
Total tattletale (read only) 14 N/A
Configuration Group 1
FLEXED PARAMETER - gov gain 5080 8 character string
FLEXED PARAMETER - gov minimum 191 8 character string
FLEXED PARAMETER - gov gain 573 8 character string