GASKET 7E6615 - Caterpillar

Illustration 1 g02025733
Schematic of the Cat Data Link CircuitThis diagnostic code is recorded when the Machine ECM does not receive expected information from the Engine ECM. Use Cat® ET and check the Machine and the Engine ECM for other diagnostic codes related to the data link. If a related diagnostic code is present, troubleshoot and correct that fault first. The possible causes of this diagnostic code are listed below:
The wires for the Cat Data Link to the Engine ECM are open or the wires are shorted.
The wrong software is installed on an ECM.
The Engine or Machine ECM has failed. (ECM failure is unlikely.)Test Step 1. VERIFY THE HARDWARE AND THE SOFTWARE PART NUMBERS
Verify that the following information is correct:
The part number of the flash software for the Engine ECM
The part number of the flash software for the Machine ECM
The part number of the Engine ECM
The part number of the Machine ECMNote: Use SIS Web to find the correct part numbers of the ECM software (flash file). To download the current ECM flash file, select "Service Software Files" on the SIS web home page.Expected Result:All of the part numbers are correct.Results:
OK - All of the part numbers are correct. Proceed to Test Step 2.
NOT OK - All of the part numbers are not correct. Repair: The installed Engine ECM or the Machine ECM have the wrong part number or the incorrect flash software is installed. Replace the Engine ECM or replace the Machine ECM that is incorrect. Replace the ECM with a module that has the correct part number. Flash the correct software. See Testing and Adjusting, "Electronic Control Module (ECM) - Flash Program" for additional information.STOPTest Step 2. INSPECT THE HARNESS CONNECTIONS
Turn the disconnect switch to the OFF position.
Inspect all harness connections that are related to the Cat Data Link. Make sure that the connectors are clean and tight.
Check the connectors for proper mating. Ensure that all the seals are present and in place.
Check the harness for signs of damage or abrasion.
Check the wires at the connector. Ensure that the wires are secured tightly into the connector. Take care not to pull the wire out of the connector.
Check the exposed wires at the connectors for nicks or signs of abrasion.
Check for moisture inside the connector.
Check the connectors for dirty contacts or corroded contacts.
Check each pin and each socket of the machine harness connectors. Ensure that the contacts are properly installed. The contacts should mate correctly when the two pieces of the connector are placed together.Expected Result:The machine harness connectors are tight and free of corrosion.Results:
OK - The machine harness connectors are tight and free of corrosion. Proceed to Test Step 3.
NOT OK - The machine harness connectors are in need of repair.Repair: Repair the machine harness or replace the machine harness.STOPTest Step 3. CHECK FOR SHORTS
The disconnect switch remains in the OFF position.
Disconnect the machine harness connectors from all electronic control modules that use the Cat Data Link.
At the machine harness connector for the Machine ECM, measure the