GASKET 7F8833 - Caterpillar

Illustration 8 g00798531
Disconnect the wiring harness from the various connections.
Remove the entire 6P-1295 Blower As from the air conditioner case. Removal of the blower assembly includes the following items: the blower motor, the attached blower housings and the wheels.
Illustration 9 g00798220
Separate the blower housings from the assembly. Remove the two 8P-1291 Motor Mounting Plates (1A) from the motor. This is shown in Illustration 9.
Install the two 8P-1291 Motor Mounting Plates (1A) onto each of the blower housings. Use four 6V-1322 Bolts (16) and four 3B-4504 Lockwashers (17) for each 8P-1291 Motor Mounting Plate .Note: The purpose of the two 8P-1291 Motor Mounting Plates (1A) is for control of the air flow. In the past, these plates (brackets) were installed to the replacement motor. The design of the new 174-1508 Electric Motor does not permit the installation of the plates.Note: The blower housings are bolted to the large slotted holes that are in the flat area at the bottom (bracket's widest part) of the 191-7726 Bracket .
Illustration 10 g00798281
Drill two 6.35 mm (0.25 inch) holes into the flange of each blower housing. The location dimensions are shown in Illustration 10.
Illustration 11 g00833345
Install 174-1508 Electric Motor (1B). Use the following parts in order to mount the motor onto the 191-7726 Bracket (14) : two 8C-4586 Clamps (15), one 5P-5908 Seal (18), two 8T-4205 Hard Washers (19), one 6V-1322 Bolt (20) and one 129-3178 Locknut (21) .
Illustration 12 g00798552
Drill two 10.3 mm (0.41 inch) holes into the top right hand corner of the frame for the air conditioner. The location dimensions are shown in Illustration 12.
Illustration 13 g00798654
Fasten the 9X-4383 Resistor (5) to the 7T-4568 Bracket (6) by using the following parts: the 6V-3320 Screw (7), two 6V-1668 Washers (8) , two 6T-6708 Washers (9) and the 7H-8909 Locknut (10). This is shown in Illustration 13.
Use the 5M-3062 Bolts (11) and the 8T-4896 Hard Washers (12) in order to fasten the resistor assembly to the case of the air conditioner. This is shown in Illustration 13.
Illustration 14 g00834112
Assemble the new motor assembly, the blower housings and the wheels into the case for the air conditioner. Use four 5P-4115 Hard Washers (23) and four 6V-8185 Nuts (24) in order to assemble the parts to the small studs. Tighten the nuts to a torque of 19.19 4.06 N m (169.85 35.93 lb in). Use four 5P-1075 Hard Washers (25) and four 6V-8801 Nuts (26) in order to assemble the parts to the large studs. Tighten the nuts to a torque of 19.19 4.06 N m (169.85 35.93 lb in). Use Illustration 7 for the locations of the nuts and the washers.
Use three 3S-2093 Cable Straps (3) for attaching the 7X-1394 Harness As