GASKET 7L3111 - Caterpillar

Event Actions
Path: Administration > Notification > Event Actions > options
Types of Notification
You can configure event actions to occur in response to an event or group of events. These actions notify users of the event in any of several ways:
Active, automatic notification. The specified users or monitoring devices are contacted directly.- E-mail notification- SNMP traps- Remote Monitoring Service- Syslog notification
Indirect notification- Event log. If no direct notification is configured, users must check the log to determine which events have occurredReferenceYou can also log system performance data to use for device monitoring. Refer to the "Data log" section in the, "Information Logs" chapter of this manual.- Queries (SNMP GETs)Reference For more information, refer to the "SNMP" section in the, "Administration : Network Features" chapter of this manual. SNMP enables an NMS to perform informational queries. SNMPv1does not encrypt data before transmission. Configuring the most restrictive SNMP access type (READ) enables informational queries without the risk of allowing remote configuration changes.Configuring Event Actions
Notification Parameters
For events that have an associated clearing event, you can also set the following parameters as you configure events individually or by group, as described in the next two sections. To access the parameters, click the receiver or recipient name.
Table 1
Parameter    Description    
Delay x time before sending     If the event persists for the specified time, notification is sent. If the condition clears before the time expires, no notification is sent.    
Repeat at an interval of x time     The notification is sent at the specified interval.    
Up to x times     During an active event, the notification repeats for this number of times.    
Until condition clears     The notification is sent repeatedly until the condition clears or is resolved.    Configuring by Event
To define event actions for an individual event:
Select the "Administration" tab, "Notification" on the top menu bar, and "by event" under "Event Actions" on the left navigation menu.
In the list of events, review the marked columns to see whether the action you want is already configured. (By default, logging is configured for all events.)
To view or change the current configuration, such as recipients to be notified by e-mail or paging, or Network Management Systems (NMSs) to be notified by SNMP traps, click the event name.Note: If no Syslog server is configured, items related to Syslog configuration are not displayed.ReferenceWhen viewing details of an events configuration, you can change the configuration, enable or disable event logging or Syslog, or disable notification for specific e-mail recipients or trap receivers, but you cannot add or remove recipients or receivers. To add or remove recipients or receivers, see the following:ReferenceRefer to "Identifying Syslog Servers"section in this chapter.ReferenceRefer to "E-mail Recipients"section in this chapter.ReferenceRefer to "Trap Receivers"section in this chapter.Configuring by Group
To configure a group of events simultaneously:
Select the "Administration" tab, "Notification" on the top menu bar, and "by group" under "Event Actions" on the left navigation menu.
Choose how to group events for configuration:- Choose "Grouped by severity", and then select all events of one