GASKET 7L4487 - Caterpillar

Illustration 57 g00518410
Place a thrust disc (99) on each side of the planetary gear. Place the planetary gear and the thrust discs in the carrier.
Illustration 58 g00518411
Install planetary shaft (100) in the carrier. The spring pin hole in the planetary shaft must align with the hole in the carrier.
Install spring pin (101) . The outer edge of the spring pin should be even with the outer edge of the carrier.
Repeat Step 103.a through Step 103.d for the remaining three planetary gears.
Illustration 59 g00518412
Install the gasket on slinger (102) .
Place slinger (102) in position on the carrier assembly.
Install the bolts and the locks that hold the slinger in position.
Illustration 60 g00518413
Attach a suitable hoist and lifting chains.
Use the hoist in order to install the carrier assembly in position in the transmission.
Install spacer (104) and retaining ring (103) .
Illustration 61 g00518414
Install ring gear (106) over the carrier assembly.
Illustration 62 g00518415
Install six reaction dowels (110) in the manifold assembly.
Put clean oil on three friction discs (108) and two clutch plates (109) .
Install the three friction discs and the two clutch plates in alternating order. Start with a friction disc and end with a friction disc. Align notches (107) with dowels (110) as clutch plates (109) are being installed.
Illustration 63 g00518416
Install the two ring seals (113) on clutch piston (112) . Install the ring seals so that the oil groove and the sealing edge will be facing toward the inside of No. 6 clutch housing.
Put clean oil on the ring seals.
Install clutch piston (112) in No. 6 clutch housing (111) .
Illustration 64 g00518417
Install 12 springs (114) in the manifold assembly.
Use Tooling (C) in order to hold the clutch piston in the No. 6 clutch housing.
Attach a suitable hoist and lifting chains.
Use the hoist in order to install the clutch housing on the manifold assembly. The mark on the clutch housing must be aligned with the mark on the manifold assembly. The 12 springs must be in the bores in the clutch piston of the No. 6 clutch housing.
Install the 18 bolts that hold the clutch housings together. Tighten the bolts to a torque of 115 7 N m (85 5 lb ft).
Perform the following steps in order to verify that the clutch pistons are free in the clutch housings.
Illustration 65 g00518418
Use Tooling (D) in order to pressurize each of the five oil passages. The air pressure should be 690 kPa (100 psi) to 1035 kPa (150 psi).
Each clutch piston should have a travel of 3.0 mm (.12 inch) to 6.4 mm (.25 inch).
If the clutch pistons do not move the correct distance, place a small amount of clean oil in the passage. Repeat Step 122.a. The transmission must be disassembled if the pistons do not move. The clutch pistons and the ring seals must be checked.
Illustration 66 g00518419
Attach a suitable hoist and lifting chains.
Use the hoist in order to place the transmission case on suitable wood blocks.
Lower the planetary assembly into the transmission case. The dowel in the manifold assembly must be aligned with the hole in the transmission case.
Install