GASKET 7M7667 - Caterpillar

Specifications
Illustration 1 g06045286
(A) Length 11 mm (0.4 inch)
Table 1
Specifications for 213-0064 Base As
Item Qty Part Specification Description
1 1 9S-4167 Hollow Stud Apply red Loctite 271 to a length of (A) to the threads.
Torque to 70 15 N m (52 11 lb ft).
Removal Procedure
Table 2
Required Tools
Tool Part Number Part Description Qty
A 185-3630 Strap Wrench As 1
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products.Dispose of all fluids according to local regulations and mandates.
Turn the fuel supply to the OFF position and turn the power disconnect switch to the OFF position.
Illustration 2 g02080637
Disconnect harness assemblies (1).
Use Tooling (A) in order to remove fuel filters (5) from fuel filter base (3).
Disconnect tube assemblies (2).
Remove bolts (4) and remove fuel filter base (3).Installation Procedure
Inspect the O-ring seals, the gaskets, and the seals for wear or for damage. Replace the components, if necessary.
Install fuel filter base (3) in the reverse order of removal.
Lubricate the seal that is found on the fuel filter with the fluid that is being sealed. Use Tooling (A) in order to tighten fuel filters (5) to a torque of 35 3 N m (26 2 lb ft).