GASKET 7N9520 - Caterpillar

Problems with the electronic control system can be reported via flash codes or diagnostic trouble codes. Flash codes provide an indication of a problem with a specific engine subsystem. Diagnostic trouble codes provide information on the engine subsystem and information that is related to the failure mode of the problem.Table 1 and Table 2 lists the cross-reference information that is necessary to locate the circuit test that will assist in diagnosing electrical problems for the engine subsystems. Inorder to diagnose a problem with a flash code that is known, locate the flash code in the table and perform the related circuit test that is listed.For information on diagnostic codes, refer to Troubleshooting, "Diagnostic Trouble Code List".Portions of this material are reprinted with permission from SAE J1939DA_201607© 2016 SAE International. SAE International is not responsible for any use or translation of this material, in whole or in part. Please contact SAE International to obtain a complete copy of SAE J1939DA_201607, the official definitive source of this standard.Cross-Reference for Flash Code to CID-FMI and Event Code
Table 1
Cross-Reference from Flash Code to CID-FMI Code/Event Code and Description to Troubleshooting Procedure
Flash Code CID-FMI Code/Event Code and Description Procedure
N/A E056(1) High Fuel Temperature Warning Troubleshooting, "Fuel Temperature is High"
E096(1) High Fuel Pressure Troubleshooting, "Fuel Pressure Is High"
E119(1) Low Fuel Level Add fuel to the fuel tank. Refer to the literature that is provided by the OEM of the vessel for the correct procedure.
E173(1) High Exhaust Temperature Warning Troubleshooting, "Exhaust Temperature Is High"
261-11 Engine Timing Offset fault Troubleshooting, "Timing - Calibrate"
268-2 Programmed Parameter Fault erratic, intermittent, or incorrect Troubleshooting, "Configuration Parameters"
535-8 Exhaust Temperature Sensor abnormal frequency, pulse width, or period Troubleshooting, "Sensor Signal (PWM) - Test"
13 174-3 Fuel Temperature Sensor voltage above normal Troubleshooting, "Sensor Signal (Analog, Passive) - Test"
174-4 Fuel Temperature Sensor voltage below normal
15 96-3 Fuel Level Sensor voltage above normal Troubleshooting, "Fuel Level - Test"
96-4 Fuel Level Sensor voltage below normal
17 168-0 Electrical System Voltage high - most severe (3) Troubleshooting, "Electrical Power Supply - Test"
21 41-3 8 Volt DC Supply voltage above normal Troubleshooting, "Sensor Supply - Test"
41-4 8 Volt DC Supply voltage above normal
262-3 5 Volt Sensor DC Power Supply voltage above normal
262-4 5 Volt Sensor DC Power Supply voltage below normal
24 100-3 Engine Oil Pressure Sensor voltage above normal Troubleshooting, "Sensor Signal (Analog, Active) - Test"
100-4 Engine Oil Pressure Sensor voltage below normal
100-10 Engine Oil Pressure Sensor abnormal rate of change
25 1785-3 Intake Manifold Pressure Sensor voltage above normal
1785-4 Intake Manifold Pressure Sensor voltage below normal
1785-10 Intake Manifold Pressure Sensor abnormal rate of change
27 110-3 Engine Coolant Temperature Sensor voltage above normal Troubleshooting, "Sensor Signal (Analog, Passive) - Test"
110-4 Engine Coolant Temperature Sensor voltage below normal
28 91-13 Throttle Position Sensor calibration required Troubleshooting, "Throttle Position Sensor - Calibrate"
1249-13 Secondary Throttle Position calibration required
32 91-8 Throttle Position Sensor abnormal frequency, pulse width, or period Troubleshooting, "Speed Control - Test"
1249-8 Secondary Throttle Position signal abnormal
34 190-8