GASKET 7W5628 - Caterpillar

Illustration 1 g03356025
Illustration 2 g03356026
Front view of engine
Table 1
Specification for 390-3456 Flywheel Housing Gp    
Item     Qty     Part     Specification Description    
Before installation of the flywheel housing, inspect the front face of the flywheel housing and the rear face of the cylinder block. The components must be free of the following substances: oil, fuel, water, gasket adhesive, assembly compounds, and any other foreign materials.    
To seal the joint between the flywheel housing and the cylinder block, apply red Loctite 596 to the front face of the flywheel housing.    
1     4     9X-8875 Bolt     Length of 1/2 inch diameter bolt is
88.90 mm (3.500 inch).
Torque to
135 20 N m (100 15 lb ft).    
2     6     9X-8873 Bolt     Length of 1/2 inch diameter bolt is
57.15 mm (2.250 inch).
Torque to
135 20 N m (100 15 lb ft).    
3     2     9M-7269 Bolt     Length of 1/2 inch diameter bolt is
171.5 mm (6.75 inch).
Torque to
135 20 N m (100 15 lb ft).    
4     2     9S-1374 Bolt     Length of 1/2 inch diameter bolt is
203.20 mm (8.000 inch).
Torque to
135 20 N m (100 15 lb ft).    
5     4     8S-9089 Bolt     Length of 1/2 inch diameter bolt is
114.30 mm (4.500 inch).
Torque to
135 20 N m (100 15 lb ft).    
6     16     1D-4590 Bolt     Length of 5/8 inch diameter bolt is
120.65 mm (4.750 inch).
Torque to
270 40 N m (199 30 lb ft).    
7     -     -     After assembly, trim gasket flush to face (8).