GASKET 9M2051 - Caterpillar

Ensure that all safety information, warnings, and instructions are read and understood before any operation or any maintenance procedures are performed. The user is responsible for the performance of all maintenance including the following procedures: all adjustments , the use of proper lubricants, fluids, filters and the installation of new components due to normal wear and aging . The performance of this product may be diminished if proper maintenance intervals and procedures are not followed. Components may experience accelerated wear if proper maintenance intervals and procedures are not followed.Note: Use whichever of the following that occurs first in order to determine the maintenance intervals: fuel consumption , service hours and calendar time . Before each consecutive interval is performed, all maintenance from the previous intervals must be performed.Products that operate in severe operating conditions may require more frequent maintenance. Refer to this Operation and Maintenance Manual , "Severe Service Application" for more information.When Required
Battery - Replace
Battery or Battery Cable - Disconnect
Coolant - Change
Coolant Extender (ELC) - Add
Engine - Clean
Engine Air Cleaner Element (Dual Element) - Inspect/Clean/Replace
Ether Starting Aid Cylinder - Replace
Fuel System - Prime
Generator - Dry
Generator Set - Test
Generator Set Alignment - Check
Rotating Rectifier - Inspect/Test
Daily
Coolant Level - Check
Engine Air Cleaner Service Indicator - Inspect
Engine Oil Level - Check
Fuel System Primary Filter/Water Separator - Drain
Generator Bearing Temperature - Test/Record
Generator Load - Check
Power Factor - Check
Walk-Around Inspection
Every 760,000 L (200,770 US gal) of Fuel
Overhaul (Top End)
Overhaul Considerations
Every Week
Automatic Start/Stop - Inspect
Electrical Connections - Check
Generator - Inspect
Generator Lead (Flat Braided Cable) - Check
Jacket Water Heater - Check
Space Heater - Test
Overhaul
Generator Bearing - Inspect/Replace
Initial 250 Service Hours
Engine Speed/Timing Sensor - Clean/Inspect
Engine Valve Lash - Check
Engine Valve Rotators - Inspect
Every 250 Service Hours
Aftercooler Core - Clean/Test
Battery Electrolyte Level - Check
Belts - Inspect/Adjust/Replace
Coolant Sample (Level 1) - Obtain
Cooling System Supplemental Coolant Additive (SCA) - Test/Add
Engine Crankcase Breather - Clean
Engine Oil Sample - Obtain
Engine Oil and Filter - Change
Engine Protective Devices - Check
Fan Drive Bearing - Lubricate
Fuel System Secondary Filter - Replace
Fuel Tank Water and Sediment - Drain
Hoses and Clamps - Inspect/Replace
Radiator - Clean
Rotating Rectifier - Check
Every 500 Service Hours
Fuel System Primary Filter (Water Separator) Element - Replace
Every 2000 Service Hours or 6 Months
Generator Lead (Round Cable) - Check
Generator Set Vibration - Inspect
Generator Set Vibration - Test/Record
Generator Winding Insulation - Test
Every Y