GASKET 9S1369 - Caterpillar

Firmware Update
DescriptionFirmware update is mandatory:
At commissioning
Machines that are in operation
The next service callIf an update is needed:
Place the system in bypass mode.
Perform the update.
Make sure that the system is on-line. This update can be made with no parts.Required Software Files
The new installation must be purchased.UPSView.exeAutoloader.exeFirmware Files that are Required
APSBootxxx.mot
apc_xxx.ttf
APSLI_COMPRESS_xxx
APSLI_internal_xxx.mot
pcc_xxx.ttf
zzc_xxx.ttfNote: "xxx" represents the version number that will change with the new firmware releases.Use the Auto Loader to update the firmware files in a UPS. The Auto Loader is a Windows application. The Auto Loader will automate the process for the technician.The first line in the dialog is the "command/status" dialog. The "command/status" dialogs will inform you of the progress of the application. If an input is required, directions will be listed.Use the pull-down menu to select the COM port of the serial device on your computer.The "Connect Button" will establish communications over the selected COM port.The "User Name and Password" fields will be accessible after communication has been established. Fill in the fields and click the "Start Button".The larger window contains detailed information on the process. There are four columns of information.
Target
IS Rev
ShB Rev
StatusThe "Target" column will have an arrow pointing to the item that is currently updating.The "IS Rev" column displays the current revision of each target prior to the update.The "ShB Rev" column displays the information that each of the targets should be.
Illustration 1 g01274002The "Status" column may contain the following information:
NA - not applicable, the UPS did not detect the equipment in the UPS
Force - the UPS will update this file regardless of current revision
Updating - the target is in the process of updating currently
Pending - the target will be programmed when the target progression gets to that target
Skipped - the file is already at the required revisionProcedure
Before starting the procedure, put the UPS into Bypass Mode. Failure to be in Bypass prior to beginning will allow the auto load application to place the UPS into bypass for you.The auto load application will not run with any instances of UPSView connected between the UPS and the computer.
Connect a PC to the UPS.
For MMS, select MMU #1 with the PCI rotary switch.
Open the UPSView application.
Establish a direct connection between UPSView and the UPS.
Enter a valid user name. Enter a valid password.
On the computer, press "Alt-Z". Record all of the "Operating Parameters" except for the defaults. The results will be used for a comparison later.
Click on the menu item "Clear Password".
Terminate communications in UPSView by clicking UPSView menu. Select "Connection" and then "Disconnect".
Close UPSView. Make sure that the UPSView window is closed. Only one form of communication is possible over the serial cable.
Open the application "Autoload.exe".
Select the appropriate COM port.
Click the "Connect" button.
Follow the instructions that are on the screen. One example of an instruction is entering a user name and password when directed. Note: If the process has a problem, a message dialog will pop up in a separate dialog.An attempt to use the auto load utility in "Recovery Mode" is possible. The auto load utility will happen