GASKET 9W2727 - Caterpillar

Installation Procedure
Table 1
Required Tools    
Tool    Part Number    Part Description    Qty    
A     5p-9694     Ratchet Hoist     1    
Inspect all parts and clean all parts. If any parts are worn or damaged, use new Caterpillar parts for replacement.
Illustration 1 g00559454
Attach Tooling (A) to the exhaust port of the truck body. Attach Tooling (A) to parking brake assembly (12). Use a second person to stabilize parking brake assembly (12). Use Tooling (A) in order to position parking brake assembly (12) to the machine. The weight of parking brake assembly (12) is 50 kg (110 lb). ()
Illustration 2 g00560541
Install six bolts (11) and the washers that secure parking parking brake assembly (12) to the machine frame. Install two bolts (13) and the washers to parking brake assembly (12). Tighten bolts (11) to a torque of 468 61 N m (345 45 lb ft). Tighten bolts (13) to a torque of 241 41 N m (178 30 lb ft). Remove Tooling (A ) from the parking brake assembly and from the exhaust port on the truck body.
Illustration 3 g00559451
Install the O-ring seal to hose (6). Connect hose (6) to actuation cylinder (1) .
Illustration 4 g00559453
Position actuation cylinder (1) to bracket (10). Install two nuts (7), the lockwashers, and the hard washers that secure actuation cylinder (1) to bracket (10) .
Illustration 5 g00564161
Start the engine in order to compress the spring that is in actuation cylinder (1) and thus disengaging the parking brake. Install Retaining pin (9) and the cotter pin that secures lever (3) to actuator arm (8). Turn wrench (4) clockwise in order to apply the contained pressure to lever (3). Adjust lever (3) to the identification mark that signifies the original adjustment of lever (3) to actuator arm (8). Stop the engine.
Before operating the machine, be sure the steering frame lock link is disconnected and put in the storage position.
, End By:
Install the center drive shaft. Refer to Disassembly and AssemblyRENR1511, "Center Drive Shaft - Remove and Install".
Separate the frame lock link. Refer to Disassembly and Assembly, "Frame Lock Link - Separate and Connect". The information is in this manual.