GAUGE GP-CLUSTER 0844377 - Caterpillar

Removal Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 311-1362 Vacuum Gauge Gp 1
B - Loctite 271 - Start By:
Release the hydraulic system pressure.
Personal injury can result from hydraulic oil pressure and hot oil.Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system.Make sure all of the work tools have been lowered to the ground, and the oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand.
Illustration 1 g02138430
Remove the cap from the hydraulic tank. Install Tooling (A) onto the hydraulic tank. Attach an air supply hose to Tooling (A). Apply 276 to 414 kPa (40 to 60 psi) of air. This procedure will pull vacuum on the hydraulic system.
Illustration 2 g02138375
Remove bolts (2) and plate assembly (1).
Illustration 3 g02138376
Disconnect hose assemblies (3) and harness assemblies (5) from control manifold (6).
Remove bolts (4) and control manifold (6).
Illustration 4 g02138434
Remove accumulator (7). Remove plate (8) from control manifold (6). Installation Procedure
Install control manifold (6) in the reverse order of removal.
Apply Tooling (B) to the threads of bolts (2).
Check the hydraulic oil level. Refer to , "Hydraulic System Oil Level - Check".