GAUGE-OIL LEVEL 1616871 - Caterpillar

Illustration 7 g06247720
(1) 3B-4626 Cotter Pin
(2) 3F-4971 Pin
(3) 4F-0255 Pin
(4) 4J-0121 Bearing Cap As
(5) 7X-2566 Bolt
(6) 8C-8478 Bolt
(7) 8E-5703 Shim
(8) 8J-2880 Bearing Cap
(9) 8T-4123 Washer
(10) 8T-4131 Nut
(11) 127-4131 Nut
(12) 128-5201 Arm As
(13) 354-0953 Blade As
Assemble blade (12) onto the push arms and braces by using the hardware indicated in Illustration 7.
Assemble the bearing caps onto the push arms. Tighten bolts (5) to a torque of 520 70 N m (385 50 lb ft).Note: Use 12 shims (7) as required.Note: Make sure the chamfer on nuts (11) aligns with the radius on the push arm bracket.
Assemble the bearing cap onto the left brace assembly. Tighten nuts (10) to a torque of 520 70 N m (385 50 lb ft).Note: Use 10 shims (7) as required.Cylinder Assembly
Table 7
Parts List
Item Qty Part
1 1 3B-4626 Cotter Pin
2 1 3F-6185 Pin
3 1 4F-0255 Pin
4 4 6V-7742 Full Nut
5 4 6V-9167 Bolt
6 24 8E-5703 Shim
7 1 8J-2880 Bearing Cap
8 1 367-9478 Tilt Cylinder Gp
Illustration 8 g06247928
(1) 3B-4626 Cotter Pin
(2) 3F-6185 Pin
(3) 4F-0255 Pin
(4) 6V-7742 Full Nut
(5) 6V-9167 Bolt
(6) 8E-5703 Shim
(7) 8J-2880 Bearing Cap
(8) 367-9478 Tilt Cylinder Gp
Assemble tilt cylinder (8) onto the blade and the right push arm by using the hardware indicated in Illustration 8.The cap, nuts, bolts, and shims, are pre-assembled onto the cylinder rod.Reverse the bolts and nuts from the shipping configuration and ensure that the threaded end of the bolts face the front of the tractor. Tighten the nuts to a torque of 520 70 N m (385 50 lb ft).Hydraulic Lines Connect
Illustration 9 g06249396
(A) Hose to the head end of the cylinder
(B) Hose to the rod end of the cylinder
Remove the rear guard assembly from the push arm. Connect the ends of the hoses onto the already installed hoses of the tilt cylinder as indicated in Illustration 9. Replace the rear guard assembly.Lift Cylinder Assembly
Illustration 10 g06251345
(B) Tooling B 470-7064 Bar
Remove Tooling B from the lift cylinders.
Illustration 11 g06251353
Assemble the lift cylinders onto the blade as indicated in Illustration 11.The cap, nuts, bolts, and shims, are pre-assembled onto the cylinder rod.Tighten the nuts to a torque of 520 70 N m (385 50 lb ft).