GAUGE AS-OIL LEVEL (DIPSTICK) 1805567 - Caterpillar

Stopping the engine immediately after it has been working under load can result in overheating and accelerated wear of the engine components.Refer to the following stopping procedure, to allow the engine to cool, and to prevent excessive temperatures in the turbocharger center housing, (if equipped) which could cause oil coking problems.
Stopping The Engine From The Operator Compartment
Illustration 1 g03111418
Illustration 2 g03724164
(1) Delayed Engine Shutdown Override
(2) OFF
(3) ON
(4) STARTNote: This procedure is used for shutting down the tractor engine and the scraper engine. When engine start switch (1) is turned to the OFF position, both engines will be shutdown.
Use the procedure that is described in Operation and Maintenance Manual, "Stopping the Machine" to stop the machine.
Run the engine at low idle for 5 minutes. Do not stop the engine immediately after the engine has been working under load.Note: If the “Regen Active” indicator is illuminated, do not shut off the engine. Refer to Operation and Maintenance Manual, "Monitoring System" for more information.
Turn engine start switch to the OFF position. Remove the engine start switch key.Note: The engine may delay before completely shutting down. Delayed engine shutdowns aid in cooling the engine and after-treatment components.Stopping The Engine From Outside Of The Operator Compartment
Note: Use the engine shutdown switch only when engine start switch (1) does not work or engine start switch (1) cannot be accessed.
Run the engine at low idle for 5 minutes. Do not stop the engine immediately after the engine has been working under load.
Illustration 3 g02126282
Move the engine shutdown switch to the OFF position. Refer to Operation and Maintenance Manual, "Engine Shutdown Switch" for further information.Note: The engine shutdown switch does not shut off the machines electrical system.Stopping The Scraper Engine From The Scraper
Run the engine at low idle for 5 minutes. Do not stop the engine immediately after the engine has been working under load.Note: There are two shutdown switches for the scraper engine. Use either switch (2) or switch (3) to stop the scraper engine.
Illustration 4 g06010063
Move the engine shutdown switch to the OFF position. Refer to Operation and Maintenance Manual, "Engine Shutdown Switch" for further information.Note: The engine shutdown switch does not shut off the machines electrical system.Delayed Engine Shutdown
The Delayed Engine Shutdown allows the engine to run for a time after the engine start switch key is turned to the OFF position to cool the engine and system components. The engine start switch key may be removed.Note: The DEF purge process will run for 2 minutes once the engine is shutdown and must complete. The purge process may occur during delayed engine shutdown. Do not turn off battery disconnect switch during the purge process. Do not turn off the battery power disconnect switch until the battery disconnect switch indicator lamp has turned off. If the purge process does not complete, a diagnostic code will become active.Note: There may be regulations that define the requirements for the operator and/or support personnel to be present when the engine is running.
Leaving the machine unattended when the engine is running may