GAUGE GP-OIL LEVEL (DIPSTICK) 2480369 - Caterpillar

ACTION REQUIRED
Refer to the attached Rework Procedure.
SERVICE CLAIM ALLOWANCES
Product smu/age whichever comes first Caterpillar Dealer Suggested Customer Suggested
Parts % Labor Hrs% Parts % Labor Hrs% Parts % Labor Hrs%
*******Group 1*******
0-500000 hrs,
0-720 mo 100.0% 100.0% 0.0% 0.0% 0.0% 0.0%
This is a 1.3-hour job for Group 1
An additional 0.7 hours is allowed if need to replace PLE601 Network Manager ECM as per Rework Procedure.
Product smu/age whichever comes first Caterpillar Dealer Suggested Customer Suggested
Parts % Labor Hrs% Parts % Labor Hrs% Parts % Labor Hrs%
*******Group 2*******
0-500000 hrs,
0-720 mo 100.0% 100.0% 0.0% 0.0% 0.0% 0.0%
This is a 1.3-hour job for Group 2
An additional 0.7 hours is allowed if need to replace PLE601 Network Manager ECM as per Rework Procedure.
PARTS DISPOSITION
Hold the failed PLE601 for 30 days for a possible Parts Return Request (PRR). Make sure to list the service letter program number on the packing slip and include the closed work order paperwork.
If a Parts Return Request (PRR) is not issued to you after 30 days through the Send-It-Back process, handle the parts in accordance with your warranty bulletin on warranty parts handling.
Rework Procedure
Before going to the Customer Site:
1. Download the following flash files to your pc for updating the PLE601 Network Manager and PL641 radio.
.
Image1.1.1
At the Machine:
2. Connect to the PLE601 following the instructions from REHS8850, section "Flashing the PLE601 Network Manager". If no Network Manager is detected, check all wiring and connections and try again. If the Network Manager continues to not be detected, replace with a new PLE601 Network Manager as per the ?Network Manager Replacement? section of REHS8850. This will be an "After Failure". Ensure failed PLE601 is retained. Refer to the Parts Disposition.
3. If the Network Manager did not need to be replaced:
A. Download a Cat Electronic Technician (Cat ET) Product Status Report.
B. Use the ECM replacement functionality in Cat ET and save the file locally.
C. Download all VIMS data, using VIMSpc (if applicable).
D. Navigate to the Service Dashboard and note any standard/customer configuration files, and any custom settings (ECM Exclusions, Modbus configurations, etc.).
4. Flash only the PLE601 with the part number as seen in Image 1.1.1 (or later if available). If flash completes in less than 35 minutes, proceed to step 5. If during the flash, flash time exceeds 35 minutes, cycle power from asset using master disconnect. If no disconnect is present, remove 70-pin connector for 10 seconds before replacing. Attempt flash again - if flash continues to take longer than 35 minutes, replace the Network Manager as per the ?Network Manager Replacement? section of REHS8850 and attempt to flash again. This will be an "After Failure". Ensure failed PLE601 is retained. Refer to the Parts Disposition.
5. Update any configuration files & settings (from step 3) if necessary.
6. If relevant, update PL641 radio with part number as seen in Image 1.1.1 (or later if available).