GAUGE-OIL LEVEL (DIPSTICK) 2964706 - Caterpillar

that all safety information, warnings, and instructions are read and understood before any operation or any maintenance procedures are performed. The user is responsible for the performance of all maintenance including the following procedures: all adjustments, the use of proper lubricants, fluids, filters and the installation of new components due to normal wear and aging . The performance of this product may be diminished if proper maintenance intervals and procedures are not followed. Components may experience accelerated wear if proper maintenance intervals and procedures are not followed.Note: Use whichever of the following that occurs first in order to determine the maintenance intervals: fuel consumption, service hours and calendar time . Before each consecutive interval is performed, all maintenance from the previous intervals must be performed.Products that operate in severe operating conditions may require more frequent maintenance.When Required
Battery - Replace
Battery or Battery Cable - Disconnect
Engine - Clean
Fuel System - Prime
Generator - Dry
Generator Bearing Temperature - Test/Record
Generator Set - Test
Generator Set Alignment - Check
Rotating Rectifier - Inspect/Test
Daily
Electrical Connections - Check
Engine Oil Level - Check
Generator Load - Check
Walk-Around Inspection
Every Week
Generator - Inspect
Every 50 Service Hours or Weekly
Fuel Tank Water and Sediment - Drain
Every 250 Service Hours
Battery Electrolyte Level - Check
Coolant Sample (Level 1) - Obtain
Initial 500 Hours (for New Systems, Refilled Systems, and Converted Systems)
Coolant Sample (Level 2) - Obtain
Every 500 Service Hours
Belts - Inspect/Adjust/Replace
Fuel System Primary Filter/Water Separator - Drain
Fuel System Secondary Filter - Replace
Every 500 Service Hours or 1 Year
Engine Oil Sample - Obtain
Engine Oil and Filter - Change
Fuel System Primary Filter (Water Separator) Element - Replace
Hoses and Clamps - Inspect/Replace
Every 1000 Service Hours or 1 Year
Rotating Rectifier - Check
Every 2000 Service Hours
Alternator - Inspect
Engine Mounts - Inspect
Starting Motor - Inspect
Every 2000 Service Hours or 6 Months
Generator Set Vibration - Test/Record
Generator Winding Insulation - Test
Every Year
Battery - Recycle
Coolant Sample (Level 2) - Obtain
Every 3000 Service Hours
Fuel Injector - Replace
Water Pump - Inspect
Every 3000 Service Hours or 2 Years
Coolant Temperature Regulator - Replace
Every 6000 Service Hours or 3 Years
Coolant Extender (ELC) - Add
Every 12 000 Service Hours or 6 Years
Coolant (ELC) - Change
Overhaul
Overhaul Considerations