AVSPARE.COM
parts catalog

GAUGE-OIL 3236266 - Caterpillar



3236266 GAUGE-OIL Caterpillar parts 236B, 246C, 256C, 262C, 267B, 268B, 272C, 277C, 287C, 297C, 3044C, 3126E GAUGE
Rating:
23
Alternative (cross code) number:
CA3236266
323-6266
3236266
Caterpillar 3236266 GAUGE-OIL
Weight: 0.05 pounds 0 kg.

Buy GAUGE-OIL 3236266 Caterpillar genuine, new aftermarket tractor parts with delivery
INDUSTRIAL ENGINE, TRUCK ENGINE,

Compatible equipment models: 3236266:

INDUSTRIAL ENGINE  3044C  
MULTI TERRAIN LOADER  267B   277C   287C   297C  
SKID STEER LOADER  236B   246C   256C   262C   268B   272C  
TRUCK ENGINE  3126E   Caterpillar
Number on catalog scheme: 6
 
  For full view, you need register

Information:


Illustration 1 g00439248
Schematic for the Lift Lower SolenoidThis diagnostic code is recorded when the ECM detects a short to the +battery in the electrical path that goes from the ECM to the solenoid back to the ECM.The possible causes for this diagnostic code are listed:
The signal circuit from the ECM to the solenoid is shorted to the +battery.
The return circuit from the solenoid is shorted to the +battery.System Response:The machine response is listed:
All electrohydraulic valves are turned off.
The pilot on/off solenoid valve is turned off.
Implement functions are disabled until the fault is corrected and the levers are centered.Note: All solenoid return lines connect to contacts J1-7 and J2-3 (wire 716-WH) of the implement ECM.Note: The following test procedure may create other diagnostic codes. Ignore these created diagnostic codes and clear the diagnostic codes when the original diagnostic code is corrected.Note: Ensure that the diagnostic code is active and that the diagnostic code indicator is active.Test Step 1. CHECK THE SOLENOID.
Turn the key start switch to the OFF position.
Disconnect the solenoid with the diagnostic code from the harness.
Turn the key start switch to the ON position.
Place the direction lever in the NEUTRAL position.
At the harness connector for the solenoid, measure the voltage from the ECM between contact 1 (wire H716-WH) and contact 2 (wire H714-OR). Expected Result: The voltage is approximately 5 DCV.Results:
YES - The voltage is approximately 5 DCV.Repair: The solenoid has failed. Replace the solenoid. Stop.
NO - The voltage is approximately battery voltage. Proceed to Test Step 2.Test Step 2. CHECK THE HARNESS.
Turn the key start switch to the OFF position.
Disconnect the harness from the ECM.
Turn the key start switch to the ON position.
At the harness connector for the ECM, measure the voltage between contact J1-2 (wire A272-BK) and contact J1-4 (wire H714-OR).Expected Result:The voltage is approximately battery voltage.Results:
YES - The voltage is approximately battery voltage.Repair: There is a short to the +battery in the harness. Repair the harness or replace the harness. Stop.
NO - The voltage is approximately 0 DCV. The cause or the diagnostic code has not been found. Proceed to Test Step 3.Test Step 3. CHECK IF THE DIAGNOSTIC CODE REMAINS.
Turn the key start switch to the OFF position.
Inspect all harness connectors and reconnect.
Turn the key start switch to the ON position.
Enter service mode.
Operate the machine and ensure that the same diagnostic code is active.Expected Result: The diagnostic code is active.Results:
YES - The diagnostic code is active.Repair: The diagnostic code has not been corrected. It is unlikely that the ECM has failed. Exit this procedure and perform this troubleshooting procedure again. If the cause of the diagnostic code is not found, replace the ECM. See Testing and Adjusting, "Electronic Control Module (ECM) - Replace". Stop.
NO - The diagnostic code is inactive.Repair: The diagnostic code does not exist at this time. The initial diagnostic code was probably caused by a poor electrical connection at one of the harness connectors that was disconnected and reconnected. Resume normal machine operation. Stop.

Caterpillar parts catalog:

Caterpillar parts catalog
3126E Truck Engine 9SZ00001-UP
3044C Industrial Engine 34400001-UP
236B 246B 252B 262B SKID STEER LOADER HEN00001-06749 (MACHINE) POWERED BY 3044C Engine
248B 268B SKID STEER LOADER LBA00001-UP (MACHINE) POWERED BY 3044C Engine
267B, 277B and 287B Multi Terrain Loader CYC00001-UP (MACHINE) POWERED BY 3044C Engine
297C Multi Terrain Loader GCP00001-UP (MACHINE) POWERED BY 3044C Engine
262C Skid Steer Loader MST00001-UP (MACHINE) POWERED BY 3044C Engine
272C Skid Steer Loader RED00001-UP (MACHINE) POWERED BY 3044C Engine
277C Multi Terrain Loader JWF00001-UP (MACHINE) POWERED BY 3044C Engine
287C Multi Terrain Loader MAS00001-UP (MACHINE) POWERED BY 3044C Engine
246C Skid Steer Loader JAY00001-UP (MACHINE) POWERED BY 3044C Engine
256C Skid Steer Loader DWS00001-UP (MACHINE) POWERED BY 3044C Engine


Parts gauge Caterpillar catalog:

1706305 GAUGE GP-FUEL LEVEL
216, 216B, 216B3, 226B, 226B3, 232B, 236B, 236B3, 242B, 242B3, 247B, 247B3, 252B, 252B3, 257B, 257B3, 259B3, 267B, 268B, 414E, 416D, 416E, 420D, 420E, 422E, 424D, 428D, 428E, 430D, 430E, 432D, 432E, 4...
2076154 GAUGE-SIGHT
216, 216B, 216B3, 226B, 226B3, 228, 232B, 236, 236B, 236B3, 242B, 242B3, 246C, 247, 247B, 247B3, 248, 252B, 252B3, 256C, 257B, 257B3, 259B3, 262C, 267, 267B, 268B, 272C, 277C, 279C, 287, 287C, 289C, 2...
2669769 GAUGE-OIL LEVEL
3126, 3126B, 3126E, C7
1584439 GAUGE-OIL LEVEL
3126B, 3126E, C7, C9
1593596 GAUGE-OIL LEVEL
3126, 3126B, 3126E, C11, C13, C7
1446645 GAUGE-OIL LEVEL
3116, 3126, 3126B, 3126E, C7
1518378 GAUGE-OIL LEVEL
3126, 3126B, 3126E, C7
2613572 GAUGE-OIL LEVEL
422E, 428E, 432E, 434E, 442E, 444E
3418236 GAUGE-OIL LEVEL (DIPSTICK)
416E, 422E, 428E, 432E, 434E, 442E, 444E
2189984 GAUGE AS-OIL LEVEL (DIPSTICK)
420E, 428E, 430E, 432E, 434E, 442E, 444E
2717167 GAUGE-OIL LEVEL
414E, 416E, 420E, 422E, 428E, 430E, 432E, 434E, 442E, 444E
3418235 GAUGE-OIL LEVEL (DIPSTICK)
414E, 416E, 420E, 422E, 428E, 430E, 432E, 434E, 442E, 444E
2508304 GAUGE AS-OIL LEVEL (DIPSTICK)
420D, 428D, 430D, 432D, 442D
2678390 GAUGE GP-SIGHT
246C, 256C, 262C, 262C2, 272C, 277C, 277C2, 279C, 279C2, 287C, 287C2, 289C, 289C2, 297C, 299C, 450E, 450F
3355769 GAUGE-OIL LEVEL (DIPSTICK)
256C, 262C, 272C, 277C, 279C, 287C, 289C, 297C, 299C
3098909 GAUGE GP-OIL LEVEL (DIPSTICK)
236B, 236B3, 242B3, 246C, 252B, 252B3, 256C, 257B3, 259B3, 262C, 262C2, 272C, 277C, 277C2, 279C, 279C2, 287C, 287C2, 289C, 289C2, 297C, 299C
1301161 GAUGE AS-OIL LEVEL (DIPSTICK)
3034, 3054, 3054B, 3054C, 3054E, 3056, 3056E, C4.4, PF-290B, PS-150B, PS-200B, PS-360B, TH210, TH215
3622973 GAUGE-SIGHT
216B, 216B3, 226B, 226B3, 232B, 236B, 236B3, 236D, 242B, 242B3, 242D, 246C, 246D, 247B, 247B3, 252B, 252B3, 256C, 257B, 257B3, 257D, 259B3, 259D, 262C, 262C2, 262D, 267B, 268B, 272C, 272D, 272D XHP, 2...
2354956 GAUGE-OIL
236B, 267B, 268B
Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.