GAUGE GP-OIL LEVEL (DIPSTICK) 3590903 - Caterpillar

Note: For additional information on control levers and joystick control, refer to Operation and Maintenance Manual, "Operator Controls" for the machine that is being serviced.
Illustration 3 g01182233
Location of the Connector for Caterpillar Electronic Technician (ET)
Connect the Caterpillar Electronic Technician (ET) to the machine according to the following directions. Connect the 7X-1425 Data Link Cable to an available COM port on your PC and to the connector on the 7X-1700 Communication Adapter. Connect the 139-4166 Data Link Cable to the connector on the 7X-1700 Communication Adapter and to the service connector on the machine.Reference: For additional information on use of the Caterpillar Electronic Technician (ET), refer to Troubleshooting and Testing and Adjusting, "Using Caterpillar Electronic Technician to Determine Diagnostic Codes" for the machine that is being serviced.
Turn the key start switch to the ON position.
Open the software program for the ET.
Illustration 4 g01182393
Select "Implement (for the machine that is being serviced)" from the "ECM Selector" screen and click on the "OK" button.
Illustration 5 g01182396
Select "Service" menu in the ET.
Select "Calibrations" from the "Service" menu.
Select "Lever Calibrations" from the "Calibrations" menu.
Illustration 6 g01171796
The screen will display all the control levers that are available on the machine. Once you have selected the control levers to calibrate, select the "Begin" button. The screen will change in order to display step-by-step instructions for calibrating the control lever. Note: The ET software defaults so that all the control levers will be selected for calibration. Select the check mark button next to an individual control lever in order to remove a control lever from the calibration procedure.Note: If the machine is equipped with a joystick control, follow the same strategy that is used by the control levers.
Illustration 7 g01208823
Select the "Next" button in order to begin the calibration. A check mark button will be placed to the left of a completed step and the next step will be highlighted in bold text. After successful completion of a step, you may need to select the "Next" button in order to begin the following step. Follow the steps that are listed in the bottom section of the screen until the calibration procedure is complete.Note: The ET screen will be divided into three display areas. The top section of the screen will be used to display important status parameters that are monitored during the calibration. The middle section of the screen displays the information about the calibration procedure. The bottom section of the screen displays the step-by-step instructions for the calibration. The step that currently needs to be performed will be in bold text. All other steps will be displayed in gray text.
Illustration 8 g01171814
When the calibration is complete, ET will display a status screen. The status screen will inform you if the calibration was successful. Select the "Continue" button in order to go to the next calibration or the "Cancel" button in order to end the calibrations.
Illustration 9 g01208824
Select the "Next" button in order to begin the next calibration.
Illustration 10 g01171821
After a calibration has been completed, ET will display a status screen. Note: The implement