GAUGE AS-OIL LEVEL (DIPSTICK) 3802596 - Caterpillar

Table 1
Service Tools    
Part Number    Part    
6V-7800
9U-7330
212-2126
146-4080 (1)     Digital Multimeter    
8T-3224     Needle Tip Group    
7X-1710     Multimeter Probe Group    
8T-8726     Cable Assembly (three Pin)    
6V-3000     Connector Repair Kit (Sure Seal)    
9U-7246     Connector Repair Kit (Deutsch DT Type)    
4C-3406     Connector Repair Kit (Deutsch)    
( 1 ) This multimeter is capable of using an RS232C cable to hook up to a laptop computer or Dataview for troubleshooting.
Illustration 1 g01298310
Connections for the Communication Adapter II and the Cat® Electronic Technician (Cat ET) Service Tool.The components that are needed to use the Communication Adapter II and Cat ET for the determination of the diagnostic codes are listed: (1) Cable (2) 171-4400 Communication Adapter II (3) Service diagnostic cable. (4) Current version of Cat ET software and an IBM-COMPATIBLE personal computerReferenceRefer to Special Publication, NEHS0758, "Communications Adapter II User's Manual Contains Software".Note: Cat® Electronic Technician (Cat ET) Service Tool is a software program that can be used on an IBM compatible personal computer. In order to use the Cat ET, order the following materials:
Special Publication, JERD2124, "ET Single Use Program License"
Special Publication, JEHP1026, "Information and Requirements Sheet"
7X-1425 Data Link Cable and the Data Subscription
Special Publication, JERD2142, "Data Subscription"
Special Publication, JEHP1026, "Information and Requirements Sheet"For instructions on servicing Sure Seal connectors, refer to Special Instruction, SMHS7531. For service instructions about the Deutsch "DT" Type connectors, refer to Special Instruction, SEHS9615.Cat ET is not required to determine and clear the diagnostic codes. However, the process of determining the diagnostic codes is easier and faster by using Cat ET. Cat ET can also display information on the history and the parameter status of diagnostic codes. These features allow Cat ET to be a useful tool for troubleshooting.Cat ET is used to communicate to the electronic control module over the data link by connecting to the machine diagnostic connector. For more information and the locations of the connectors, refer to Troubleshooting, "Electrical Components and Connector Locations" and the Electrical System Schematic in your machine Service Manual.Use the digital multimeter for making continuity checks or for measuring voltage. For instructions about the use of the Digital Multimeter, refer to the owners manual that is provided with the multimeter. The 7X-1710 Multimeter Probe is used to measure the voltage at the connectors without disconnecting the connectors. The probe cables are pushed into the back of the connector along the wire. The 8T-8726 Adapter Cable has a breakout (three pin). The adapter cable is used for measurements in the sensor circuits.Note: Except for harness tests, using continuity testers such as the 8T-0500 Continuity Tester or voltage testers such as the 5P-7277 Voltage Tester is not recommended for Caterpillar electrical circuits.