GAUGE-FUEL LEVEL 3867045 - Caterpillar

Illustration 1 g00847502
Note: Assemble this linkage on the machine by rotating the rod end of the bucket cylinder and by positioning the grease fitting away from the stick. Coat all the bores for pins with lubricant. (1) 201-2837 Pin Diameter after plating ... 99.85 0.04 mm (3.931 0.002 inch) Minimum thickness for plating ... 0.013 mm (0.0005 inch) (2) 166-1488 Shim thickness ... 2.0 mm (0.08 inch) (3) Lubricate the sealing lip slightly with the lubricant that is being sealed. (4) 4I-4807 Pin Diameter after plating ... 79.85 0.04 mm (3.144 0.002 inch) Minimum thickness for plating ... 0.013 mm (0.0005 inch)Note: Make sure that the bearings are installed in the bore so that the identification numbers of the bearings are facing outward. (5) 087-5548 Sleeve Bearing Quantity ... 2 Outside diameter ... 116.230 0.013 mm (4.5760 0.0005 inch) Inside diameter ... 100.290 0.020 mm (3.948 0.001 inch) Install the bearing in the bearing bore. ... 9.5 0.3 mm (0.37 0.01 inch) (6) 189-6063 Pin Diameter after plating ... 79.85 0.04 mm (3.144 0.002 inch) Minimum thickness for plating ... 0.013 mm (0.0005 inch) (7) 189-6062 Pin Diameter after plating ... 99.85 0.04 mm (3.931 0.002 inch) Minimum thickness for plating ... 0.013 mm (0.0005 inch)Note: Make sure that the bearings are installed in the bore so that the identification numbers of the bearings are facing outward. (8) 203-7343 Sleeve Bearing Quantity ... 2 Outside diameter ... 95.18 0.013 mm (3.747 0.0005 inch) Inside diameter ... 80.250 0.020 mm (3.1594 0.0008 inch) Install the bearing in the bearing bore. ... 9.5 0.8 mm (0.37 0.03 inch) (9) Position the four nuts past the end of the four bolts. ... 0.5 0.5 mm (0.02 0.02 inch) (10) Tighten the four nuts against four nuts (9) .