GAUGE GP- 4766885 - Caterpillar

Installation Procedure
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the machine. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide", for tools and supplies suitable to collect and contain fluids in Caterpillar machines.Dispose of all fluids according to local regulations and mandates.
Clean all parts and inspect all parts. If any parts are worn or damaged, use new Caterpillar parts for replacement.
Illustration 1 g00455738
Install the elevator control valve to the machine. The elevator control valve weighs 35 kg (77 lb). Install two bolts (34) and (33) to elevator control valve (2) . Remove the nylon lifting strap and the hoist from the elevator control valve.
Illustration 2 g00455737
Install tube (32) to elevator control valve (2) and tighten two retaining nuts (31) and (30) .
Illustration 3 g00455736
Connect hose (29) to elevator control valve (2) and tighten retaining nut (28) .
Illustration 4 g00455735
Connect hose (27) to elevator control valve (2) and tighten retaining nut (26) .
Illustration 5 g00455734
Position hose (25) to elevator control valve (2) . Install two half flanges (24) and four bolts (23) to elevator control valve (2) .
Illustration 6 g00455733
Position hose (22) to elevator control valve (2) . Install two half flanges (21) and four bolts (20) to elevator control valve (2) . Position hose (19) to elevator control valve (2) . Install two half flanges (18) and four bolts (17) to elevator control valve (2) .
Illustration 7 g00455732
Install yoke rod end (16) to elevator control valve (2) . Install pin (15) to yoke rod end (16) . Install cotter pin (14) to pin (15) . Connect hose (13) to elevator control valve (2) and tighten retaining nut (12) .
Illustration 8 g00455731
Install bracket (4) to the machine. Install two bolts (11) to bracket (4) .
Illustration 9 g00455729
Install two bolts (10) to bracket (4) . Connect tube (9) and tighten retaining nut (8) .
Illustration 10 g00455728
Install four bolts (6) to fender (7) .
Illustration 11 g00455727
Connect electrical connection (5) and install electrical connection (5) to the clip. Install the clip and bolt (3) to bracket (4) . Install the clip and nut (1) to the elevator control valve (2) .
Fill the hydraulic tank. Refer to Owner's Manual, SEB6447 for information on refilling the hydraulic tank.