GAUGE-OIL LEVEL 5261111 - Caterpillar

Illustration 1 g02570108
Rear view
Illustration 2 g02570111
Tightening sequence
Table 1
Specification for 293-8242 Flywheel Housing Gp    
Item     Qty     Part     Specification Description    
-     -     -     Before installation of the flywheel housing, inspect the front face of the flywheel housing and the rear face of the rear housing. The components must be free of the following substances: oil, fuel, water, assembly compounds, and any other contaminants.    
-     -     -     Check assembled installation depth of the crankshaft seal group with the crankshaft in any axial position.    
-     -     -     Use the following procedure to tighten the flywheel housing bolts. Tighten the bolts in the numerical sequence as shown in the Illustration 2.    
1     2     245-3803 Bolt     Tighten bolt (1) through bolt (2) to
55 10 N m (41 7 lb ft).    
2     8     4Y-5853 Bolt     Tighten bolt (3) through bolt (10) to
135 20 N m (100 15 lb ft).    
3     20     0L-1143 Bolt     Tighten bolt (11) through bolt (30) to
47 9 N m (35 7 lb ft).    
4     -     -     The seal driver must not contact the seal within the
177.80 0.25 mm (7.000 0.010 inch) diameter.    
The seal and the sleeve of the crankshaft seal group must not be used if the seal and the sleeve have been separated.
A     -     -     Distance from the sleeve to the seal is
6.55 to 6.15 mm (0.258 to 0.242 inch).    
C     -     -     Installation depth of the sleeve from the rear face of the crank shaft is
1.5 0.5 mm (0.06 0.02 inch).