GAUGE 5362914 - Caterpillar

Installation Procedure
Table 2
Required Tools    
Tool     Part Number     Part Description     Qty    
A     -     Guide Bolts
3/8 - 16 NC by 4 inch     2    
B     -     Guide Bolts
1/2 - 13 NC by 4 inch     2    
C     138-7575     Link Bracket     2    
D     1U-9393     Damper Guide Pin     2    
E     -     Molybdenum Disulfide Base Lubricant     -    
The following steps are for installation of the vibration damper as a complete assembly.
Illustration 11 g01207444
Install Tooling (D) . Use a suitable lifting device and slide vibration damper assembly (14) onto Tooling (D) . The weight of vibration damper assembly (14) is approximately 116 kg (255 lb). Install bolts (11) .Note: Ensure that the mark on vibration damper (14) is aligned with the mark on the crankshaft.Note: Apply Tooling (E) to the threads of bolts (11) prior to installation.
Remove Tooling (D) and install two bolts (11) .Note: Refer to Specifications, "Vibration Damper" for the correct torque.Note: If it was necessary to install the vibration damper as an assembly, proceed to Step 8.
Illustration 12 g00916309
Install Tooling (C) and a suitable lifting device to hub (13) . Install hub (13) and pulley hub (12) . The weight of hub (13) and pulley hub (12) is approximately 36 kg (80 lb). Install bolts (11) .Note: Apply Tooling (E) to the threads of bolts (11) prior to installation.Note: Refer to Specifications, "Vibration Damper" for the correct torque.
Illustration 13 g00916389
Install Tooling (B) . Install Tooling (C) and a suitable lifting device onto vibration damper (10) . Position vibration damper (10) onto Tooling (B) . Install vibration damper (10) . The weight of vibration damper (10) is approximately 50 kg (110 lb).Note: Ensure that the mark on vibration damper (10) is aligned with the mark on the crankshaft.
Illustration 14 g00916297
Illustration 15 g00916292
Install bolts (9) into vibration damper (10) . Remove Tooling (B) and install two bolts (9) .Note: Refer to Specifications, "Vibration Damper" for the correct torque.
Illustration 16 g00916284
Illustration 17 g00916274
Install Tooling (A) . Use two people and install vibration damper (8) . The weight of vibration damper (8) is approximately 30 kg (65 lb). Install bolts (7) . Remove Tooling (A) and install two bolts (7) .Note: Ensure that the mark on vibration damper (8) is aligned with the mark on the crankshaft.Note: Refer to Specifications, "Vibration Damper" for the correct torque.
Illustration 18 g01054420
Install key (5) and hub (6) . Tighten set screw (4) in hub (6) .
Illustration 19 g01051456
Install a suitable lifting device onto pulley (1) . Install pulley (1) . The weight of pulley (1) is approximately 39 kg (85 lb). Install bolts (2) .
Illustration 20 g01207380
Check the position of pulley (1) .