GAUGE AS-OIL LEVEL 7W9353 - Caterpillar

106-8557 Electric Starting Motor Gp
Illustration 1 g00726271
Illustration 2 g00726283
When the electric starting motor is viewed from the drive end, the motor rotates in the following direction. ... ClockwiseNo load conditions at 25°C (77°F) Speed ... 6800 RPM minimum Current ... 155 amp maximum Voltage ... 23 V (1) Tighten the nut on the battery terminal to the following torque. ... 30.5 3.5 N m (22 3 lb ft) (2) Tighten the ground terminal to the following torque. ... 30.5 3.5 N m (22 3 lb ft) (3) Tighten the nut on the switch terminal to the following torque. ... 2.25 0.25 N m (20 2 lb in)Note: The switch terminal must be insulated with heat shrink tubing. Do not use molded terminals. (4) Tighten the nut on the motor terminal to the following torque. ... 30.5 3.5 N m (22 3 lb ft) (5) Tighten the nut on the motor frame terminal to the following torque. ... 25 7 N m (18 5 lb ft)Solenoid
Current draw at 24 V and 25°C (77°F) Pull-in windings ... 64 amp at 24 V Hold-in windings ... 10 amp at 24 VMounting Position
Illustration 3 g00726327
(A) The electric starting motor must be engine mounted with the start solenoid: ... 15° minimum above horizontal (B) Allowable range 106-8559 Electric Starting Motor Gp
Illustration 4 g00282688
Typical example
Illustration 5 g00489813
Typical solenoid connectionsWhen the electric starting motor is viewed from the drive end, the motor rotates in the following direction. ... ClockwiseNo load conditions at 25°C (77°F) Speed ... 8450 1250 RPM Current ... 65 15 amp Voltage ... 23 V (1) Tighten the nut on the battery terminal to the following torque. ... 30.5 3.5 N m (22 3 lb ft) (2) Tighten the ground terminal to the following torque. ... 30.5 3.5 N m (22 3 lb ft) (3) Tighten the nut to the following torque. ... 2.25 0.25 N m (20 2 lb in) (4) Tighten the nut on the switch terminal to the following torque. ... 2.25 0.25 N m (20 2 lb in) (5) Tighten the nut on the motor terminal to the following torque. ... 14.7 3.4 N m (11 3 lb ft)Note: The internal torx screw must be held during tightening or loosening of the motor terminal nut. (6) Tighten the nut on the motor frame terminal to the following torque. ... 8 3 N m (71 27 lb in)Solenoid
Current draw at 20 V and 25°C (77°F) Pull-in windings ... 56.5 4.5 amp at 20 V Hold-in windings ... 14.6 amp at 20 VMounting Position
Illustration 6 g00726327
(A) The electric starting motor must be engine mounted with the start solenoid: ... 15° minimum above horizontal (B) Allowable range