GAUGE & WARNING GP 8G4917 - Caterpillar

Removal Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A - Guide Stud
(5/8 - 18 x 8 inch) 2 Start By:
Remove the flywheel. Refer to Disassembly and Assembly, "Flywheel - Remove".
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 1 g01105747
Install Tooling (A). Note: Do not remove Tooling (A). Tooling (A) will support the rear crankshaft gear while the flywheel is removed.
Remove bolts (1). Remove crankshaft seal (2).
If necessary, remove bolts (3) and cover (4).