GAUGE & WARNING GP 8G4918 - Caterpillar

Illustration 19 g03832257
Rear view of console
(5) 392-7082 Cover As
(16) 332-2155 Push Button Switch
Place Push Button Switch (16) into the top of Cover As (5) where indicated in Illustration 19. Secure using the lock washer and nut provided by Push Button Switch (16).
Illustration 20 g03832318
(6) 422-7815 Control Wiring Gp
(16) 332-2155 Push Button Switch
(19) 230-5010 Connector Plug As
Connect the pigtail from Push Button Switch (16) into Connector Plug As. (19) by inserting the white pigtail wire into position 1 on Connector Plug As. (19). Insert the brown pigtail wire into position 2 and the black pigtail wire into position three on Connector (19) . Connect the assemble pigtail from Push Button Switch (16) and connector (19) into the harness connection shown on Control Wiring Group (6).
Illustration 21 g03832329
Top view
(15) 449-4002 Film
(16) 332-2155 Push Button Switch
Place Film (15) into position next to Push Button Switch (16).
Illustration 22 g03607496
Bottom view
(3) 337-9106 Cover
(14) 9X-2043 Screw
Assemble Cover (3) to the bottom of the bracket assembly using four Screws (14). Refer to Illustration 22.
Illustration 23 g03607537
(1) Film
(5) 392-7082 Cover As
(11) 8R-3695 Grommet
Assemble four Grommets (11) to Cover As (5). Assemble Film (1) to Cover As (5). Refer to Illustration 23.
Apply 416-5285 film for 966M XE and 972M XE machines (serial number P6C1-up & EDW1-up).
Apply 285-8016 film for any other model of machine.
Illustration 24 g03607757
(P) Clip
(6) 422-7815 Control Wiring Gp
Press the Fore/Aft Adjustment Knob (R) and collapse the slide. Use retained Clip (P) to secure Control Wiring Gp (6). Install the clip over the green tape on the harness. Secure the clip to the rear bolt of the bracket. Refer to Illustration 24. Installation of Control and Mounting Group
Illustration 25 g03607828
(D) Bolt
Assemble mounting group to the seat using the four retained bolts, washers, and spacers. Refer to Illustration 25.
Illustration 26 g03607879
(C) Screws
(6) 422-7815 Control Wiring Gp
Assemble Control Wiring Gp (6) to the rear of the seat using retained Screws (C). Refer to Illustration 26.
Illustration 27 g03607897
(A) Wiring Harness Connectors
(B) Wiring Harness Connectors
Reattach the Wiring Harness Connectors that were detached at location (A) and location (B). Refer to Illustration 27. Joystick Installation Status
Illustration 28 g03607920
Using Caterpillar Electronic Technician (ET), configure the joystick to enable operation.