GAUGE AS-OIL LEVEL (DIPSTICK) 8R0512 - Caterpillar

Illustration 29 g06125708
Illustration 30 g06125693
Position spool (41), reaction arm (40), washer (38), levers (37), and spring (38) into control block (31).
Install spring (36) and O-ring seal (35) onto eccentric pin (34).
Install eccentric pin (34) into control block (31). Install retainer (33) and bolt (32). Tighten bolt (32) to a torque of 5 1 N m (44 9 lb in).
Illustration 31 g06125425
Install O-ring seals (30), cartridges (29), coil assemblies (28), O-ring seals (27), and nuts (26).
Illustration 32 g06125420
Illustration 33 g06125412
Install gasket (25).
Position valve group (24) onto the pump housing. Install cover (23) and bolts (22).
Illustration 34 g06125406
Illustration 35 g06125393
Improper assembly of parts that are spring loaded can cause bodily injury.To prevent possible injury, follow the established assembly procedure and wear protective equipment.
Install O-ring seals (21), spool (20), and spring (19) onto valve assembly (18).
Use a M6 mm. x 1.0 bolt and a suitable press to install valve assembly (18) and retaining ring (17) into manifold (15).
Illustration 36 g06125367
Install O-ring seals (16) into manifold (15).
Illustration 37 g06125359
Install manifold (15) and bolts (14). Tighten bolts (14) to a torque of 51 5 N m (38 4 lb ft).
Illustration 38 g06126759
Install gear (13), gear (12), and O-ring seal (11) onto charge pump body (5).
Illustration 39 g06125329
Install clips (10) and (9) into adapter (4).
Illustration 40 g06126757
Install plate (8) and retainers (7) onto charge pump body (5). Install adapter (4).
Illustration 41 g06125305
Install charge pump body (5) adapter (4) and O-ring seal (3) into pump housing (6).
Illustration 42 g06125291
Install cover (2) and bolts (2). Tighten bolts (2) to a torque of 43 4 N m (32 3 lb ft).
Remove from Tooling (A) or suitable fixture.
Remove from Tooling (A) or suitable fixture.End By:
Install the piston pump.