GAUGE-OIL LEVEL 9Y0324 - Caterpillar

Start By:
Separate the track.Note: Cleanliness is an important factor. Before the disassembly procedure, the exterior of the component should be thoroughly cleaned. This will help to prevent dirt from entering the internal mechanism.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Personal injury can result from hydraulic oil pressure and hot oil.Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system.Make sure all of the work tools have been lowered to the ground, and the oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand.
Note: Put identification marks on all lines, on all hoses, on all wires, and on all tubes for installation purposes. Plug all lines, hoses, and tubes. This helps to prevent fluid loss and this helps to keep contaminants from entering the system.
Illustration 1 g01195409
Attach Tooling (A) and a suitable lifting device to cover (2). The weight of cover (2) is approximately 39 kg (85 lb).
Remove bolts (1) and cover (2).
Illustration 2 g01191960
Disconnect hose assemblies (3), (4), and (5) .
Illustration 3 g01191963
Remove bolts (6) and bolts (7).
Remove cover (8) .
Illustration 4 g01191964
Illustration 5 g01191965
Attach Tooling (A) to cover (9) .
Remove bolts (10) and cover (9) from track roller frame (11) .
Illustration 6 g01191966
Pull hose assemblies (12) through track roller frame (11) .
Position hose assemblies (12) aside.
Illustration 7 g01191967
Use Tooling (B) to raise the machine in order to lift the track roller frame off the track.
Illustration 8 g01191968
Illustration 9 g01191969
Attach a suitable lifting device to track roller frame (11). The weight of track roller frame (11) is approximately 6124 kg (13500 lb).
Use Tooling (C) in order to remove bolts (13) and (14). Repeat for the rear.
Use the suitable lifting device to remove track roller frame (11) .Installation Procedure
Install track roller frame (11) in the reverse order of removal.