GEAR G 0535159 - Caterpillar

Specifications
Illustration 1 g02563096
Table 1
Specification for the 338-3454 Electric Starting Motor Gp and 352-9766 Electric Motor Gp
Item Qty Part Specification Description
B - - Clearance between the pinion and the housing is 9.1 mm (0.36 inch).
1 5 6V-8188 Nut Torque to 30.5 3.5 N m (269.9 31.0 lb in).
2 1 4B-2049 Nut Torque to 3.4 1.2 N m (30.1 10.6 lb in).
3 1 4B-2049 Nut The switch terminal must be insulated with heat shrinkable tubing. Do not use molded terminals.
Torque to 3.4 1.2 N m (30.1 10.6 lb in).
4 1 6V-8188 Nut A maximum of three cable terminals or wire terminals may be used with the battery terminal nut. A maximum of two of the cable terminals may be equal to or greater than 0 AWG.
Torque to 30.5 3.5 N m (269.9 31.0 lb in).
- - - Pull-in current at 20 V and 25 °C (77 °F) is 49.3 3.3 Amp.
Hold-in current at 20 V and 25 °C (77 °F) is 6.8 Amp max.
- - - When the electric starting motor is viewed from the pinion end, the motor rotates in the clockwise direction.
- - - No load conditions at 25 °C (77 °F):
Speed is 6950 1650 rpm.
Current draw is 115 25 Amp.
Voltage is 23 VDC. Removal Procedure
Illustration 2 g03620560
Remove plate (1) and plate (2).
Illustration 3 g03620660
Remove bracket (3).
Illustration 4 g03620597
Remove nut (3) and cover (4). Remove nut (5) (Behind cover (4)) in order to disconnect the wire assembly. Remove nut (6) in order to disconnect the cable assembly. Remove nut (7) in order to disconnect the cable assembly.
Illustration 5 g03620603
Attach a suitable lifting device to electric starting motor (8). The weight of electric starting motor (8) is approximately 36 kg (80 lb). Remove bolts (9). Remove electric starting motor (8). Remove the gasket (not shown) from electric starting motor (9). Installation Procedure
Install electric starting motor (8) in the reverse order of removal.
Tighten nut (7) to a torque of 31 4 N m (274 35 lb in)
Tighten nut (6) to a torque of 31 4 N m (274 35 lb in)
Tighten nut (5) to a torque of 4 1 N m (35 9 lb in)