GEAR 0964341 - Caterpillar

Do not continuously operate the refueling pump for more than 30 minutes. Do not operate the refueling pump more than a few seconds without fuel. Pump damage can result.
Illustration 1 g01133152
(1) Cap
(2) Sight gauge
(3) Storage box Use the following procedure to pump fuel and store the hose.
Open the outside cover of the storage box (3) that is located at the front of the machine.
Remove cap (1) from the fuel tank, in order to allow proper ventilation.
Illustration 2 g01133053
(4) Hose end
(5) On switch
Insert the free end of the suction hose (4) into a container of fuel.
Push the on switch (5) in order to supply the fuel to the tank. When the tank is full, the pump stops refueling. Note: Check sight gauge (2) in order to determine the fuel level.
After refueling, install the cap on the fuel tank.
Make sure that excess fuel is drained from the suction hose before storing the suction hose.
Wind the hose on the bracket. Place the end of the hose onto the holder.
To prevent hose damage, do not coil the hose in a tight radius.
Close the outside cover of the storage box.