GEAR-CRANKSHAFT 1011370 - Caterpillar

Updating Firmware
Illustration 1 g03404424
From the "File" menu in UPS View, select "Update Firmware". The window that is indicated by illustration 1 will be shown.
To update the flywheel system's firmware, click in the "Select target to be programmed" window.
Illustration 2 g00851508
Illustration 3 g00851518
Click on the "Browse" icon in order to find correct firmware file.When the "Browse" button is clicked, the window that is shown in illustration 2 is shown.Clicking on the "Advanced" icon will cause the window that is indicated in Illustration 3.
Click on the "Program" icon.Note: Click "Exit" in order to cancel an update when "Program" has been selected. The programming will not be written to the flash and the processor will be restarted.The following list gives descriptions of some of the icons."Program" - "Program" initiates the download of the firmware to the UPS."Reload Device" - "Reload Device" will reset the device that is being programmed."Browse" - "Browse" allows the user to select the proper firmware file from a disk."Exit" - "Exit" will cancel a program that is in progress, but "Exit" needs to be selected before the target file has been written to flash memory. If "Exit" is selected during the read back verification, "Exit" will only cancel the verification."Advanced" - "Advanced" opens a dialog box with several custom settings."Enter optional starting address:" - "Enter optional starting address:" is only available on byte-wide flash. This is an offset into flash memory. Do not use the "Enter optional starting address:" unless you have been specified."Output debug log file?" - "Output debug log file?" will open a log file. The log file monitors the flash program. This is strictly a tool for checking for errors. This should not be enabled without specific need."Full read back checking? (Recommended)" - "Full read back checking? (Recommended)" enables the read back verification of the flash memory after flash memory has been programmed. Flash memory read back and verification is recommended.UPS 300
Install UPS VIEW 2.2 or a later version of the software.Note: This must be installed before you continue with this procedure.
Place the keyswitch in the bypass position. If this is a MMS, place the keyswitch on the system cabinet to the bypass position.
On a SMS, if it is possible, isolate the system and power down the system.
Connect the laptop computer to the RS232 connector that is located on the System I/O board on a SMS. Apply power. In a MMS, connect the laptop computer to the PCI and select the appropriate MMU via the selector switch.
Start UPS View.
Enter the username and the password.
Click "OK".
From the "File" menu, select "Update Firmware".If this system is a SMS, proceed to step 14.Note: In a MMS, it is critical not to reset the processor or loose power during the update of the Serial FPGA20k and the PCC. Update the Serial FPGA20k and update the PCC before the processor is reset.
Illustration 4 g03404426
Proceed by selecting "Serial Flash PCC" for the target.
Illustration 5 g00846410
Click "Browse". Find the file "pcc*.ttf". Click on the file "pcc*.ttf".This file is on a floppy disk or on