GEAR-PLANETARY 1104799 - Caterpillar

Removal Procedure ( 3003 Engine)
Start By:
Remove the electric starting motor. Refer to Disassembly and Assembly, "Electric Starting Motor - Remove and Install".
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Support the engine with blocks or a suitable lifting device on a flat surface.
Illustration 1 g00585274
Remove two bolts (2) that fasten the flywheel housing to the backplate.
Remove two bolts (3) that fasten the backplate to the flywheel housing.
Remove flywheel housing (1) from the rear of the engine.Installation Procedure ( 3003 Engine)
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 2 g00585274
Position flywheel housing (1) on the rear of engine.
Install two bolts (3) that fasten the backplate to the flywheel housing.
Install two bolts (2) that fasten the flywheel housing to the backplate.Tighten the flywheel housing bolts for the 3003 engine to the following torque: ... 50 N m (37 lb ft)End By: Install the electric starting motor. Refer to Disassembly and Assembly, "Electric Starting Motor - Remove and Install".Removal Procedure ( 3013, 3014 and 3024 Engines)
Table 1
Required Tools    
Tool    Part Number    Part Description    Qty    
A     138-7573     Link Bracket     1    Start By:
Remove the flywheel. Refer to Disassembly and Assembly, "Flywheel - Remove".
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Support the engine with blocks or a suitable lifting device on a flat level surface.
Illustration 3 g00585650
Remove the bolt and clamp (1) in order to remove the hose and the clamp from the engine.
Illustration 4 g00585658
Remove two bolts (2) that fasten the flywheel housing to the cylinder block.
Illustration 5 g00585719
Illustration 6 g00585724
Install Tool (A) and a suitable lifting device on the flywheel housing.
Remove three bolts (4) on each side of the cylinder block. These bolts fasten the flywheel housing to the cylinder block.
Remove two bolts (3) that fasten the backplate to the flywheel housing.
Remove four nuts and four bolts (5) that fasten the backplate to flywheel housing (6) .
Illustration 7 g00585878
Use a suitable lifting device to remove flywheel housing (6) from the cylinder block.The weight of the flywheel housing is 18 kg (40 lb).Installation Procedure ( 3013, 3014 and 3024 Engines)
Table 2
Required