GEAR & BEARING GP-SWING 1141434 - Caterpillar

Turn the keyswitch to the OFF position.
Connect the 9U-5795 Current Probe to a DMM (digital multimeter) or use a 225-8266 Ammeter Tool Gp . Clamp the probe around the alternator output wire ("B+"). Before you clamp the probe around the wire, ensure that the probe is "zeroed" .
Read the current.Expected Result: The current is under 2 A.Results:
YES - The current is under 2 A. Continue to Step 4.
NO - The current is over 2 A. There is an internal problem with the alternator. Replace the alternator or go to Testing and Adjusting, "Component - Test".
Disconnect the B+ terminal wire from the alternator. Connect the red lead of the multimeter to the wire that was disconnected. Connect the black lead of the multimeter to the alternators B+ terminal. Set the multimeter on the 10 amp scale. Read the current. Expected Result: The current is under 0.015 A.Results:
YES - The current is under 0.015 A. The alternator is operating correctly. There is a current draw on the machine. Go to Testing and Adjusting, "T7 Identifying Source Of Current Draw - Test".
NO - The current is over 0.015 A. There is an internal problem with the alternator. Replace the alternator or go to Testing and Adjusting, "Component - Test".