GEAR-SUN 1210026 - Caterpillar

Transmission Fill
Place the transmission direction lever in the NEUTRAL position.
The parking brake must be ENGAGED.
Engine must be set to greater than 1600 rpm (high idle).
Transmission oil temperature must be at least 60 °C (140 °F).
Machine (track) speed must be zero.
Table 3
Caterpillar Monitoring System    
Step     Process     Display     Error
Condition Not Met    
1     Continue when the setup conditions are met         Initialize calibration     E04
E05
E06
E07
E08
E09    
2     Calibration Initializing     0     Left to right scrolling character        
3     Calibrating Clutch 1     1     Left to right scrolling character        
4     Calibrating Clutch 2     2     Left to right scrolling character        
5     Calibrating Clutch 3     3     Left to right scrolling character        
6     Calibrating Clutch 4     4     Left to right scrolling character        
7     Calibrating Clutch 5     5     Left to right scrolling character        
8     Calibration Complete         No blinking        Left Brake Touchup Pressure
Parking brake must be disengaged.
Engine must be set to low idle.
Transmission temperature must be at least 60 °C (140 °F).
Transmission direction lever in third Forward (3F) position.Note: Second and third gear lockout will not affect calibration.
Table 4
Caterpillar Monitoring System    
Step    Process    Display    Error
Condition Not Met    
1     Continue when the setup conditions are met         Initialize calibration        
2     CALIBRATING     Calibration Value     Clear -increment / Operater -decrement switches        Right Brake Touchup Pressure
Parking Brake must be disengaged.
Engine Must be set to low idle.
Transmission temperature must be at least 60 °C (140 °F).Note: Inadequate temperature will not fail calibration.
Transmission direction lever in third Forward (3F) position.Note: Second and third gear lockout will not affect calibration.
Table 5
Caterpillar Monitoring System    
Step    Process    Display    Error
Condition Not Met    
1     Continue when the setup conditions are met         Initialize calibration        
2     CALIBRATING     Calibration Value     Clear -increment / Operator -decrement switches        Steering Control Position
Parking brake must be disengaged.
Engine must be set to 0 RPM.
Table 6
Caterpillar Monitoring System    
Step     Process     Display     Error
Condition Not Met    
1     Continue when the setup conditions are met         Initialize calibration     E02
E03
E09
E18    
1     Setup conditions are not met.                
2     When requested action is complete proceed to next step     Rt     Use Clear - Increment switch as the next command        
3     When requested action is complete proceed to next step     L     Use Clear - Increment switch as the next command        
4     When requested action is complete proceed to next step     Rt     Use Clear - Increment switch as the next command