GEAR-PLANETARY 1345991 - Caterpillar

Illustration 3 g03734458
Swing Pump (M318F)
(1) High-pressure cutoff valve
(2) Pressure tap
Illustration 4 g03734474
Swing Pump (M320F and M322F)
(1) High-pressure cutoff valve
(2) Pressure tap
Connect tooling (B2) 41,368 kPa (6,000 psi) pressure sensor to pressure tap (2).
Clear all personnel from the machine and from the area around the machine.
Start the engine.
Set the engine speed dial at "10".
Set the swing aggressiveness to 5.
Illustration 5 g03722433
Press the "Menu" key to display the main menu options.
Illustration 6 g03722870
Use the arrows to select "Performance" mode from the "Main Menu". Press the "OK" key.
Illustration 7 g03722869
Select "Adjustments" mode from the "Performance" menu. Press the "OK" key.
Illustration 8 g03735305
Select "Swing Aggressiveness" mode from the "Adjustment" menu.
Set the "Swing Aggressiveness" to "5". Change the value with the arrow buttons. Press"OK" when done.
Lower the left console.
Illustration 9 g02446738
Power mode control button located on the soft panel switch
Push down on the power mode control button in order to activate power mode.Note: The indicator light will be illuminated when power mode is activated.
Illustration 10 g02447036
Automatic Engine Speed Control (AESC) as displayed on the programmable function key in the monitor.
Disable the automatic engine speed control through the monitor by pressing the programmable button.
Illustration 11 g03722432
Hydraulic modulation switch on left joystick
Illustration 12 g06174873
Hydraulic modulation medium mode (monitor display)
Select the hydraulic modulation mode as medium. Press the lower front switch on the left joystick to select the hydraulic modulation mode.
The air conditioning should be turned off for the following test.Test Procedure
Move the joystick to the full SWING LEFT position and to the full SWING RIGHT position.
Check the pressure reading at pressure tap (2) for the swing cutoff pressure for swing left. Check the pressure at pressure tap (2) for the swing cutoff pressure for swing right. Refer to Table 1 for the correct pressure.
If the high-pressure cutoff for the swing is not set to the proper specification, refer to the following "Adjustment Procedure".Adjustment Procedure
Personal injury or death can result from sudden machine movement.Sudden movement of the machine can cause injury to persons on or near the machine.To prevent injury or death, make sure that the area around the machine is clear of personnel and obstructions before operating the machine.
Loosen the locknut on the adjustment screw for high-pressure cutoff valve (1).
Turn the adjustment screw for high-pressure cutoff valve (1) clockwise in order to increase the pressure. Turn the adjustment screw for high-pressure cutoff valve (1) counterclockwise in order to decrease the pressure.Note: Make the final pressure adjustment on the pressure rise.
While the adjustment screw for high-pressure cutoff valve (1) is being held, tighten the locknut to the specified torque.
Repeat the"Test Procedure" until the high-pressure cutoff has been met.